Related papers: Theory of a double-dot charge detector
We perform a nonperturbative analysis of a charge qubit in a double quantum dot structure coupled to its detector. We show that strong detector-dot interaction tends to slow down and halt coherent oscillations. The transitions to a…
Charge detection utilizing a highly biased quantum point contact has become the most effective probe for studying few electron quantum dot circuits. Measurements on double and triple quantum dot circuits is performed to clarify a back…
We report the dispersive charge-state readout of a double quantum dot in the few-electron regime using the in situ gate electrodes as sensitive detectors. We benchmark this gate-sensing technique against the well established quantum point…
Charge qubits formed in double quantum dots represent quintessential two-level systems that enjoy both ease of control and efficient readout. Unfortunately, charge noise can cause rapid decoherence, with typical single-qubit gate fidelities…
Measurement of charge configurations in few-electron quantum dots is a vital technique for spin-based quantum information processing. While fast and high-fidelity measurement is possible by using proximal quantum dot charge sensors, their…
We consider a nanomechanical resonator coupled to a double quantum dot. We demonstrate how the finite-frequency current noise spectrum through the double quantum dot can be used to distinguish classical and quantum behaviour in the nearby…
We study the dynamics of a charge qubit that is capacitively coupled to an open double quantum dot. Depending on the qubit state, the transport through the open quantum dot may be resonant or off-resonant, such that the qubit affects the…
Quasi-static transport measurements are employed on a laterally defined tunnel-coupled double quantum dot. A nearby quantum point contact allows us to track the charge as added to the device. If charged with only up to one electron, the…
The charging energy of a quantum dot is measured through the effect of its potential on the conductance of a second dot. This technique allows a measurement of the scaling of the dot's charging energy with the conductance of the tunnel…
Electronic transport through a two-path triple-quantum-dot system with two source leads and one drain is studied. By separating the conductance of the two double dot paths, we are able to observe double dot and triple dot physics in…
We analyze the information that one can learn about the state of a quantum two-level system, i.e. a qubit, when probed weakly by a nearby detector. We consider the general case where the qubit Hamiltonian and the qubit's operator probed by…
We have operated a quantum point contact (QPC) charge detector in a radio frequency (RF) mode that allows fast charge detection in a bandwidth of tens of megahertz. We find that the charge sensitivity of the RF-QPC is limited not by the…
We report on dual-gate reflectometry in a metal-oxide-semiconductor double-gate silicon transistor operating at low temperature as a double quantum dot device. The reflectometry setup consists of two radio-frequency resonators respectively…
We evaluate the charge noise acting on a GaAs/GaAlAs based semiconductor double quantum dot dipole-coupled to the voltage oscillations of a superconducting transmission line resonator. The in-phase ($I$) and the quadrature ($Q$) components…
Detection of moving charge in free space is presented in the framework of single electron CMOS devices. It opens the perspective for construction of new type detectors for beam diagnostic in accelerators or for the detection of solar wind.…
Quantum mechanics can strongly influence the noise properties of mesoscopic devices. To probe this effect we have measured the current fluctuations at high-frequency (5-90 GHz) using a superconductor-insulator-superconductor tunnel junction…
We measure current by counting single electrons tunneling through an InAs nanowire quantum dot. The charge detector is realized by fabricating a quantum point contact in close vicinity to the nanowire. The results based on electron counting…
Quantum dots are frequently used as charge sensitive devices in low temperature experiments to probe electric charge in mesoscopic conductors where the current running through the quantum dot is modulated by the nearby charge environment.…
A highly sensitive charge detector is realized for a quantum dot in an InAs nanowire. We have developed a self-aligned etching process to fabricate in a single step a quantum point contact in a two-dimensional electron gas and a quantum dot…
We present the experimental realization of a Quantum Dot (QD) operating as a high-frequency noise detector. Current fluctuations produced in a nearby Quantum Point Contact (QPC) ionize the QD and induce transport through excited states. The…