Related papers: Superconducting tunable flux qubit with direct rea…
We present a readout method for superconducting flux qubits. The qubit quantum flux state can be measured by determining the Josephson inductance of an inductively coupled DC superconducting quantum interference device (DC-SQUID). We…
We present a new readout method for a superconducting flux qubit, based on the measurement of the Josephson inductance of a superconducting quantum interference device that is inductively coupled to the qubit. The intrinsic flux detection…
Superconducting qubits with in-situ tunable properties are important for constructing a quantum computer. Qubit tunability, however, often comes at the expense of increased noise sensitivity. Here, we propose a flux-tunable superconducting…
We report measurements on two superconducting flux qubits coupled to a readout Superconducting QUantum Interference Device (SQUID). Two on-chip flux bias lines allow independent flux control of any two of the three elements, as illustrated…
We have implemented a resonant circuit that uses a SQUID as a flux-sensitive Josephson inductor for qubit readout. In contrast to the conventional switching current measurement that generates undesired quasi-particles when the SQUID…
We present a novel readout scheme for phase qubits which eliminates the read-out SQUID so that the entire qubit and measurement circuitry only requires a single Josephson junction. Our scheme capacitively couples the phase qubit directly to…
We develop a high speed on-chip flux measurement using a capacitively shunted SQUID as an embedded cryogenic transducer and apply this technique to the qualification of a near-term scalable printed circuit board (PCB) package for frequency…
A phase-slip flux qubit, exactly dual to a charge qubit, is composed of a superconducting loop interrupted by a phase-slip junction. Here we propose a tunable phase-slip flux qubit by replacing the phase-slip junction with a charge-related…
Tunable Josephson harmonics open new avenues for qubit design. We demonstrate a superconducting circuit element consisting of a tunnel junction in series with a SQUID loop, yielding a Josephson potential whose harmonic content is strongly…
Quantum computation requires high-fidelity qubit readout, preserving the quantum state. In the case of superconducting (SC) qubits, readout is typically performed using a complex analog experimental setup operated at room temperature, which…
Quantum computing using superconducting circuits underwent rapid development in the last decade. This field has propelled from quantum manipulation of single two-level systems to complex designs employing multiple coupled qubits allowing…
An important desired ingredient of superconducting quantum circuits is a readout scheme whose complexity does not increase with the number of qubits involved in the measurement. Here, we present a readout scheme employing a single microwave…
The superconducting fluxonium circuit is an RF-SQUID-type flux qubit that uses a large inductance built from an array of Josephson junctions or a high kinetic inductance material. This inductance suppresses charge sensitivity exponentially…
A double SQUID manipulated by fast magnetic flux pulses can be used as a tunable flux qubit. In this paper we study the requirements for the qubit operation, and evaluate dissipation and decoherence due to the manipulation for a typical…
We study a readout scheme of superconducting flux qubit state with a Cooper pair box as a transmon. The qubit states consist of the superpositions of two degenerate states where the charge and phase degrees of freedom are entangled. Owing…
Single-shot readout experiments were performed on the two lowest-energy states of a superconducting qubit with three Josephson junctions embedded in a superconducting loop. We measured the qubit state via switching current Isw of a…
We replace the Josephson junction defining a three-junction flux qubit's properties with a tunable direct current superconducting quantum interference devices (DC-SQUID) in order to tune the qubit gap during the experiment. We observe…
Aluminum-based Josephson junctions are currently the main sources of nonlinearity for control and manipulation of superconducting qubits. A phase-slip junction, the dual of a Josephson junction, provides an alternative source of…
We show a novel method for controlling the coupling of flux-based qubits by means of a superconducting transformer with variable flux transfer function. The device is realized by inserting a small hysteretic dc SQUID with unshunted…
We present a measurement protocol for a flux qubit coupled to a dc-Superconducting QUantum Interference Device (SQUID), representative of any two-state system with a controllable coupling to an harmonic oscillator quadrature, which consists…