Related papers: Solid Friction from stick-slip to pinning and agin…
A simple model for solid friction is analyzed. It is based on tangential springs representing interlocked asperities of the surfaces in contact. Each spring is given a maximal strain according to a probability distribution. At their maximal…
It is shown on the basis of scaling arguments that a disordered interface between two elastic solids will quite generally exhibit static and "dry friction" (i.e., kinetic friction which does not vanish as the sliding velocity approaches…
A deterministic theory describing the melting of an ultrathin lubricant film between two atomically smooth solid surfaces has been developed. The lubricant state is described by introducing a parameter of excess volume that arises owing to…
The adhesive and frictional response of an AFM tip connected to a substrate through supramolecular host-guest complexes is investigated by dynamic Monte Carlo simulations. The variation of the pull-off force with the unloading rate recently…
Using molecular dynamics (MD) we study the dependency of the contact mechanics on the sliding speed when an elastically soft slab (block) is sliding on a rigid substrate with a ${\rm sin} (q_0 x)$ surface height profile. The atoms on the…
Wear is well known for causing material loss in a sliding interface. Available macroscopic approaches are bound to empirical fitting parameters, which range several orders of magnitude. Major advances in tribology have recently been…
We discuss the stick-slip motion of an elastic block sliding along a rigid substrate. We argue that for a given external shear stress this system shows a discontinuous nonequilibrium transition from a uniform stick state to uniform sliding…
By using ab-initio-accurate force fields and molecular dynamics simulations we demonstrate that the layer stiffness has profound effects on the superlubricant state of two-dimensional van der Waals heterostructures. These are engineered to…
Particle-based simulations of discontinuous shear thickening (DST) and shear jamming (SJ) suspensions are used to study the role of stress-activated constraints, with an emphasis on resistance to gear-like rolling. Rolling friction…
Particles suspended in a Newtonian fluid raise the viscosity and also generally give rise to a shear-rate dependent rheology. In particular, pronounced shear thickening may be observed at large solid volume fractions. In a recent article…
We develop an analytical model of adhesive wear between two unlubricated rough surfaces, forming micro-contacts under normal load. The model is based on an energy balance and a crack initiation criteria. We apply the model to the problem of…
Sliding friction across a thin soft lubricant film typically occurs by stick-slip, the lubricant fully solidifying at stick, yielding and flowing at slip. The static friction force per unit area preceding slip is known from molecular…
Contact mechanics-based models for the friction of nominally flat rough surfaces have not been able to adequately capture certain key experimentally observed phenomenona, such as the transition from a static friction peak to a lower level…
We have devised an original laboratory experiment where we investigate the frictional behaviour of a single crystal salt slider over a large number of deformation cycles. Because of its physical properties, salt, a surrogate for natural…
Dry solid friction is often accompanied by force modulations originating from stick-slip instabilities. Here a distinct, quasi-static mechanism is evidenced leading to quasi-periodic force oscillations during sliding contact between an…
We study the sliding friction for viscoelastic solids, e.g., rubber, on hard flat substrate surfaces. We consider first the fluctuating shear stress inside a viscoelastic solid which results from the thermal motion of the atoms or molecules…
Frictional properties of contacts between a smooth viscoelastic rubber and rigid surfaces are investigated using a torsional contact configuration where a glass lens is continuously rotated on the rubber surface. From the inversion of the…
The onset of frictional instabilities, e.g. earthquakes nucleation, is intimately related to velocity-weakening friction, in which the frictional resistance of interfaces decreases with increasing slip velocity. While this frictional…
We develop a theory of static friction by modeling the homogeneous surfaces of contact as being composed of a regular array of compressible elastic smooth microscopic inclines. Static friction is thought of as the resistance due to having…
We study the friction between a flat solid surface where polymer chains have been end-grafted and a cross-linked elastomer at low sliding velocity. The contribution of isolated grafted chains' penetration in the sliding elastomer has been…