Related papers: Comparison between step strains and slow steady sh…
In stellar interiors shear flows play an important role in many physical processes. So far helioseismology provides only large-scale measurements, and so the small-scale dynamics remains insufficiently understood. To draw a connection…
We study average flow properties in porous media using a two-dimensional network simulator. It models the dynamics of two-phase immiscible bulk flow where film flow can be neglected. The boundary conditions are biperiodic which provide a…
We study shear yielding and steady state flow of glassy materials with molecular dynamics simulations of two standard models: amorphous polymers and bidisperse Lennard-Jones glasses. For a fixed strain rate, the maximum shear yield stress…
A reasonably accurate representation of a polymer chain is provided by beads connected with rods, or stiff, inextensible springs that mimic a single Kuhn step. Due to high computational cost, coarse-grained bead-spring models are used in…
A simple model for solid friction is analyzed. It is based on tangential springs representing interlocked asperities of the surfaces in contact. Each spring is given a maximal strain according to a probability distribution. At their maximal…
Saffman and Turner (1957) argued that the collision rate for droplets in turbulence increases as the turbulent strain rate increases. But the numerical simulations of Dhanasekaran et al. (2021) in a steady straining flow show that the…
A crystal plasticity theory was developed for use in simulations of dynamic loading at high pressures and strain rates. At pressures of the order of the bulk modulus, compressions o(100%) may be induced. At strain rates o(10^9)/s or higher,…
Disordered solids distort and fail as particle contacts become unstable and rearrange under sufficiently large shear strains. Such instabilities can occur at different locations and, because of their proximity, can interact with one…
We study the strain response to steady imposed stress in a spatially homogeneous, scalar model for shear thickening, in which the local rate of yielding \Gamma(l) of mesoscopic `elastic elements' is not monotonic in the local strain l.…
We investigate the dynamics of microcapsules in linear shear flow within a reduced model with two degrees of freedom. In previous work for steady shear flow, the dynamic phases of this model, i.e. swinging, tumbling and intermittent…
Roll-wave trains constitutes a well-known two-phase flow regime in pipes. There exists a one-parameter family of steady roll-wave train solutions, provided the flow conditions are within the roll-wave range. This means that wave train…
We investigated the transient relaxation of a Discontinuous Shear Thickening suspension of cornstarch in water. We performed 2 types of relaxation experiments starting from a steady shear in a parallel plate rheometer, followed by either…
Modelling the sudden depressurisation of superheated liquids through nozzles is a challenge because the pressure drop causes rapid flash boiling of the liquid. The resulting jet usually demonstrates a wide range of structures, including…
We study theoretically the hydrodynamics of a fluid drop containing oriented filaments endowed with active contractile or extensile stresses and placed on a solid surface. The active stresses alter qualitatively the wetting properties of…
Complex fluids exhibit a variety of exotic flow behaviours under high stresses, such as shear thickening and shear jamming. Rheology is a powerful tool to characterise these flow behaviours over the bulk of the fluid. However, this…
Traditionally, stress fluctuations in flowing and deformed materials are overlooked, with an obvious focus on average stresses in a continuum mechanical approximation. However, these fluctuations, often dismissed as noise, hold the…
We study a model describing the slow flow of a fluid through a deformable, porous, elastic solid undergoing small deformations. The stress-strain relationship of the solid incorporates nonlinear effects, formulated as a perturbation of the…
We investigate dilation-induced surface deformations in a Discontinuous Shear Thickening (DST) suspension to determine the relationship between dilation and stresses in DST. Video is taken at two observation points on the surface of the…
A Stokes experiment for foams is proposed. It consists in a two-dimensional flow of a foam, confined between a water subphase and a top plate, around a fixed circular obstacle. We present systematic measurements of the drag exerted by the…
An elastic sheet that deforms near a solid substrate in a viscous fluid is a situation relevant to various dynamical processes in biology, geophysics and engineering. Here, we study the relaxation dynamics of an elastic plate resting on a…