Related papers: Stark effect of the Au(111) and Cu(111) surface st…
We report a quantitative low-temperature Scanning Tunneling Spectroscopy (STS)study on the Ag(111) surface state over an unprecedented range of currents (50 pA to 6 $\mu$A)through which we can tune the electric field in the tunnel junction…
We study the light emission from a Ag(111) surface when the bias voltage on a scanning tunneling microscope (STM) junction is ramped into the field emission regime. Above the vacuum level, scanning tunneling spectroscopy (STS) shows a…
Probing optical Stark effect at the single-molecule or atomic scale is crucial for understanding many photo-induced chemical and physical processes on surfaces. Here we report a study about optical Stark effect of single atomic defects on…
We investigate the effects of strain on a crystal surface close to the bulk melting temperature T_m, where surface melting usually sets in. Strain lowers the bulk melting point, so that at a fixed temperature below but close to T_m the…
The influence of the tip-substrate bias induced electrical field in a scanning tunneling spectroscopy experiment on colloidal InAs nanocrystals has been studied. Calculating the Stark induced splitting of the degenerate 1P_e state…
Single Co atoms, which exhibit a Kondo effect on Cu(111), are contacted with Cu and Fe tips in a low-temperature scanning tunneling microscope. With Fe tips, the Kondo effect persists with the Abrikosov-Suhl resonance significantly…
We present a quantitative many-body analysis using the GW approximation of the decay rate $\Gamma$ due to electron-electron scattering of excitations in the Shockley surface state band of Ag(111), as measured using the scanning tunnelling…
Stark effect is observed in many natural and artificial plasmas and is of great importance for diagnostic purposes. Since this effect alters profiles of spectral lines, it should be taken into account when assessing chemical composition of…
Strain can affect the morphology of a crystal surface, and cause modifications of its reconstruction even when weak, as in the case of mechanical bending. We carried out calculations of strain-dependent surface free energy and direct…
Direct imaging of single molecules at nanostructured interfaces is a grand challenge, with potential to enable new, precise material architectures and technologies. Of particular interest are the structural morphology and spectroscopic…
The Kondo temperature $T_K$ of single Co adatoms on monolayers of Ag on Cu and Au(111) is determined using Scanning Tunneling Spectroscopy. $T_K$ of Co on a single monolayer of Ag on either substrate is essentially the same as that of Co on…
We have used scanning tunneling microscopy to study the structure of graphene islands on Au(111) grown by deposition of elemental carbon at 950{\deg}C. Consistent with low-energy electron microscopic observations, we find that the graphene…
We demonstrate the application of a fiber-coupled quantum-dot-in-a-tip as a probe for scanning electric field microscopy. We map the out-of-plane component of the electric field induced by a pair of electrodes by measurement of the…
Recently the doping of topological insulators has attracted significant interest as a potential route towards topological superconductivity. Because many experimental techniques lack sufficient surface sensitivity, however, a definite proof…
Adding superconducting (SC) electron pairing via the proximity effect to pristinely non-superconducting materials can lead to a variety of interesting physical phenomena. Particular interest has recently focused on inducing SC into…
The light emission rate from a scanning tunneling microscope (STM) scanning a noble metal surface is calculated taking retardation effects into account. As in our previous, non-retarded theory [Johansson, Monreal, and Apell, Phys. Rev. B…
We have studied the Tamm-type surface state of La(0001) by tunneling spectroscopy within a wide range of tunneling currents from 0.1 nA to 8000 nA, thereby tuning the electric-field strength in a tip-vacuum-sample tunnel junction. We…
Atoms transferred to W(111) and W(110) tip apices from the Au(111) surface during tunneling and approach to mechanical contact experiments in STM are characterized in FIM at room temperature and at 158 K. The different activation energies…
The influence of charged STM tip on the electron transport through quantum states on a surface is studied both theoretically and experimentally. The current and the differential conductance calculations are carried out by means of the…
Low-temperature scanning tunneling spectroscopy of magnetic and non-magnetic metal atoms on Ag(111) and on Cu(111) surfaces reveals the existence of a common electronic resonance at an energy below the binding energies of the surface…