Related papers: A study of Mg adsorption on Si(001) surface from f…
Atomic oxygen adsorption on the Mo(112) surface has been investigated by means of first-principles total energy calculations. Among the variety of possible adsorption sites it was found that the bridge sites between two Mo atoms of the…
We investigate the atomic hydrogen adsorption on Mg(0001) by using density-functional theory within the generalized gradient approximation and a supercell approach. The coverage dependence of the adsorption structures and energetics is…
The adsorption of MgO molecules on a Fe(001) surface was studied using density functional theory (DFT) and projector augmented wave methods. The energetically most favored configurations for different adsorption sites considered were…
We have investigated Rb adsorption on the Si(100) surface for 0.5 and 1 monolayer coverages using the total energy method with norm-conserving pseudopotentials. For 2$\times$1 reconstruction at 1 ML coverage symmetrized dimers are found to…
First principles density functional calculations are used to study the early oxidation stages of the Mg(0001) surface for oxygen coverages 1/16 <= Theta <= 3 monolayers. It is found that at very low coverages O is incorporated below the…
First-principles calculations using density functional theory based on norm-conserving pseudopotentials have been performed to investigate the Cs adsorption on the Si(001) surface for 0.5 and 1 ML coverages. We found that the saturation…
We present a density functional study of the structural and electronic properties of small Cu_n (n=1,4) aggregates on defect-free MgO(100). The calculations employ a slab geometry with periodic boundary conditions, supercells with up to 76…
Adsorption of acetylene on Si(100) is studied from first principles. We find that, among a number of possible adsorption configurations, the lowest-energy structure is a ``bridge'' configuration, where the C$_2$H$_2$ molecule is bonded to…
CO adsorption on Cu(111) and Cu(001) surfaces has been studied within ab-initio density functional theory (DFT). The structural, vibrational and thermodynamic properties of the adsorbate-substrate complex have been calculated. Calculations…
The adsorption of rare gases on metal surfaces serve as the paradigm of weak adsorption where it is typically assumed that the adsorbate occupies maximally coordinated hollow sites. Density-functional theory calculations using the…
The adsorption of atomic oxygen and its inclusion into subsurface sites on Ag(210) and Ag(410) surfaces have been investigated using density functional theory. We find that--in the absence of adatoms on the first metal layer--subsurface…
While the small sticking coefficient for molecular hydrogen on the Si(001) surface apparently requires a large energy barrier of adsorption, no such barrier is observed in desorption experiments. We have calculated the potential-energy…
Using first-principles calculations, we systematically study the adsorption behavior of a single molecular H$_{2}$O on the Be(0001) surface. We find that the favored molecular adsorption site is the top site with an adsorption energy of…
We study adsorption sites of a single Xe adatom on Nb(110) surface using a density functional theory approach: The on-top site is the most favorable position for the adsorption. We compare the binding features of the present study to…
CO adsorption on the Pt(111) surface is studied using first-principles methods. As found in a recent study [Feibelman, et al., J. Phys. Chem. B 105, 4018 (2001)], we find the preferred adsorption site within density functional theory to be…
First-principles density-functional theory and supercell models are employed to calculate the adsorption of water molecules on the Cu(100) surface. In agreement with the experimental observations, the calculations show that a H2O molecule…
Chemisorption of CO on the stepped Cu(211) surface is studied within ab-initio density functional theory (DFT) and scanning tunneling microscopy (STM) imaging as well as manipulation experiments. Theoretically we focus on the experimentally…
The adsorption of C60 on Si(111) has been studied by means of first-principles density functional calculations. A 2x2 adatom surface reconstruction was used to simulate the terraces of the 7x7 reconstruction. The structure of several…
Using first-principles calculations, we systematically study the adsorption behaviors of molecular CO on the Be (0001) surface. By calculating the potential energy surfaces, we find that CO molecularly adsorbs on the Be surface with small…
Adsorption of benzene on the Si(100) surface is studied from first principles. We find that the most stable configuration is a tetra-$\sigma$-bonded structure characterized by one C-C double bond and four C-Si bonds. A similar structure,…