Related papers: Where does a cohesive granular heap break?
The failure probabilities or the strength distributions of heterogeneous 1D systems with continuous local strength distribution and local load sharing have been studied using a simple, exact, recursive method. The fracture behavior depends…
We report on experimentally measured drag force experienced by a solid cylinder penetrating a granular bed of glass beads including, specifically, a highly polydisperse sample with grain sizes in the range 1-100 {\mu}m. We consider both…
Instabilities and avalanches in granular flows represent hallmarks of failure: they can both disrupt industrial process flows and signal dangerous conditions, like those in grain silos and snowy mountaintops. We investigate intermittency…
The friction of a sliding plate on a thin immersed granular layer obeys Amonton-Coulomb law. We bring to the fore a large set of experimental results which indicate that, over a few decades of values, the effective dynamical…
Reproducing the key features of fracture behavior under multiaxial stress states is essential for accurate modeling. Experimental evidence indicates that three intrinsic material properties govern fracture nucleation in elastic materials:…
We study the influence of surface roughness on the adhesion of elastic solids. Most real surfaces have roughness on many different length scales, and this fact is taken into account in our analysis. We consider in detail the case when the…
A lattice model is presented for investigating the fluctuations in static granular materials under gravitationally induced stress. The model is similar in spirit to the scalar q-model of Coppersmith et al., but ensures balance of all…
Cohesive interactions between filamentous molecules have broad implications for a range of biological and synthetic materials. While long-standing theoretical approaches have addressed the problem of inter-filament forces from the limit of…
The onset of thermal convection in a horizontal layer of a colloidal suspension is investigated in terms of a continuum model for binary-fluid mixtures where the viscosity depends on the local concentration of colloidal particles. With an…
Unstable systems of fluidized grains in a very-narrow vertical tube can auto-defluidize after some time, the settling particles forming either a glass- or crystal-like structure. We carried out experiments using different polymer spheres,…
As if it has become a consensus that the slope of the granular heap is straight, and from that, an angle of repose is defined. However, closer inspection shows that the slopes are not truly straight, instead, more often they have convex…
Dynamical behavior of steady granular flow is investigated numerically in the inelastic hard sphere limit of the soft sphere model. We find distinctively different limiting behaviors for the two flow regimes, i.e., the collisional flow and…
In this study, we investigate the stability and solid fraction of columns comprised of highly non-convex particles. These particles are constructed by extruding arms onto the faces of Platonic solids, a configuration we term \emph{Platonic…
The scaling of physical forces to the extremely low ambient gravitational acceleration regimes found on the surfaces of small asteroids is performed. Resulting from this, it is found that van der Waals cohesive forces between regolith…
Anyone who has built a sandcastle recognizes that the addition of liquid to granular materials increases their stability. However, measurements of this increased stability often conflict with theory and with each other [1-7]. A…
This study investigates computationally the impact of particle size disparity and cohesion on force chain formation in granular media. The granular media considered in this study are bi-disperse systems under uniaxial compression,…
Stress induced yielding/fluidization in disordered solids, characterized by irreversibility and enhanced dissipation, is important for a wide range of industrial and geological processes. Although, such phenomena in thermal systems have…
One long-lasting puzzle in amorphous solids is shear localization, where local plastic deformation involves cooperative particle rearrangements in small regions of a few inter-particle distances, self-organizing into shear bands and…
We investigate the global failure threshold of an interconnected set of elements, when a finite fraction of the elements initially share an externally applied load. The study is done under the framework of random fiber bundle model, where…
With the aim of understanding failure modes in the peeling of silicone-based adhesive joints and, in particular, the occurrence of adhesive or cohesive failure, an experimental campaign has been conducted by considering plastic substrates…