Related papers: Magnetic shielding in MgB2/Fe superconducting wire…
For technical application in windings of coils, transformers or motors, a reinforcement of MgB2 wires and tapes is necessary to withstand applied stresses and strains and to avoid cracks in the filaments. Therefore, the response of the…
The influence of mechanical strain on the critical current (Ic) is investigated for MgB2/stainless steel (SUS316) superconducting tapes. The tapes are fabricated by using 'powder in tube' method and deformation process without any heat…
The magnetic field dependent critical current density $j_c(B)$ of a MgB$_2$ bulk sample has been obtained by means of magnetization hysteresis measurements. The $j_c(B)$ curves at different temperatures demonstrate a crossover from single…
Iron is an important sheath material for fabrication of MgB2 wires. However, the effect of Fe doping on the superconducting properties of MgB2 remains controversial. In this work, we present results of nano-scale Fe particle doping in to…
We evaluated the doping effect of two types of multiwall carbon nanotube (CNT) with different aspect ratios on MgB2/Fe monofilament wires. Relationships between microstructure, magnetic critical current density (Jc), critical temperature…
We investigated the doping effects of SWCNTs and MWCNTs on the Tc, lattice parameters, Jc(B), microstructure, and Hc2 of MgB2/Fe wire. These effects systematically showed the following sequence for Tc and the a-axis: the SWCNT doped wire <…
We report dc transport and magnetization measurements of Jc in MgB2 wires fabricated by the powder-in-tube method, using commercial MgB2 powder with 5 %at Mg powder added as an additional source of magnesium, and stainless steel as sheath…
The magnetic field $B$ dependence of the critical current $I_c$ for the vortex phase of a disordered superconductor is studied numerically at zero temperature. The $I_{c}(B)$ increases rapidly near the upper critical field $B_{c2}$ similar…
We report the studies of detailed magnetic relaxation and isothermal magnetization measurements in the vortex state of the 112-type iron-pnictide Ca$_{0.82}$La$_{0.18}$Fe$_{0.96}$Ni$_{0.04}$As$_2$ superconductor with $T_c$ $\sim$ 22 K. In…
The powder in tube method has been used to fabricate Ag and Cu clad MgB2 wires using an in-situ reaction method. The effects of short time sintering on the critical current densities of Ag and Cu clad MgB2 wires were studied. All the…
The upper critical field Hc2(T) of sintered pellets of the recently discovered MgB_2 superconductor was investigated in magnetic fields up to 16 T. The upper critical field of the major fraction of the investigated sample was determined…
The superconducting properties of copper-sheathed MgB2 wires fabricated by conventional powder-in-tube techniques and the in-situ reaction procedure are analysed. The influence of the processing conditions and initial (1+x)Mg + 2B (x = 0,…
It is argued that the stress caused by vortex cores in the mixed state of superconductors may result in a field dependent contribution to the free energy and magnetization of measurable levels. For sufficiently strong stress dependence of…
By doping MgB_2 superconductor with SiC nano-particles, we have successfully introduced pinning sites directly into the crystal lattice of MgB_2 grains (intra-grain pinning). It became possible due to the combination of counter-balanced Si…
We report the synthesis and variation of superconductivity parameters such as transition temperature Tc, upper critical field Hc, critical current density Jc, irreversibility field Hirr and flux pinning parameter (Fp) for the MgB2-xCx…
Polycrystalline MgB2 samples with 10 wt % silicon powder addition were prepared by an in-situ reaction process. Two different Si powders, one with coarse (44 mm) and the other with nano-size (<100 nm) particles were used for making samples.…
We have studied vortex pinning and dynamics in a Sr0.6K0.4Fe2As2 superconducting tape with critical current density Jc~0.1 MA/cm2 at 4.2 K and 10 T. It is found that grain boundary pinning is dominant in the vortex pinning mechanism.…
The critical current density shown by a superconductor at the extreme type-II limit is predicted to follow an inverse square-root power law with external magnetic field if the vortex lattice is weakly pinned by material line defects. It…
Measurements of the critical current density (Jc) by magnetization and the upper critical field (Hc2) by magnetoresistance have been performed for hafnium-doped MgB2. There has been a remarkable enhancement of Jc as compared to that by ion…
We study the effect of nano(n)-SiC addition on the crystal structure, critical temperature (Tc), critical current density (Jc) and flux pinning in MgB2 superconductor. X-ray diffraction patterns show that all the samples have MgB2 as the…