Related papers: Comparative Study of Dense Bulk MgB$_2$ Materials …
The influence of two important features of magnesium diboride on the macroscopic transport properties of polycrystalline MgB2 is discussed in the framework of a percolation model. While two band superconductivity does not have significant…
We report phase formation, and detailed study of magnetization and resistivity under magnetic field of MgB2 polycrystalline bulk samples prepared by Fe-tube encapsulated and vacuum (10-5 torr) annealed (750 0C) route. Zero-field-cooled…
$MgB_2$ becomes superconducting just below 40 K. Whereas porous polycrystalline samples of $MgB_2$ can be synthesized from boron powders, in this letter we demonstrate that dense wires of $MgB_2$ can be prepared by exposing boron filaments…
The influence of the nature of the boron precursor on the superconducting properties of polycrystalline MgB2 was studied. Critical current densities for the MgB2 made from high purity amorphous boron are at least a factor of three higher…
We report the growth and properties of epitaxial MgB2 thin films on (0001) Al2O3 substrates. The MgB2 thin films were prepared by depositing boron films via RF magnetron sputtering, followed by a post-deposition anneal at 850C in magnesium…
We report on study of the electronic anisotropy of the newly discovered MgB2 superconductor using the in-plane resistivity measurements in magnetic field applied perpendicular and parallel to Mg and B planes of MgB2 single crystals. The…
The effect of high pressure on structural and electronic properties of the novel superconductor \MB has been calculated using the full-potential linearized augmented-plane-wave method. Despite the layered crystal structure of \MB nearly…
Carbon-doped magnesium diboride was fabricated from pre-reacted pure MgB2 by mechanical alloying. The sample set had excellent critical current densities Jc(8T,4.2K) ranging from 15-60 kA/cm2, depending on composition. Magneto-optical…
Recently it was discovered that, under elevated pressures, MoB$_2$ exhibits superconductivity at a critical temperature, $T_c$, as high as 32 K. The superconductivity appears to develop following a pressure-induced structural transition…
This work studies the influence of microstructures and crystalline defects on the superconductivity of MgB2, with the objective to improve its flux pinning. A MgB2 sample pellet that was hot isostatic pressed (HIPed) was found to have…
Case studies of $1T$-TiSe$_2$ and YBa$_2$Cu$_3$O$_{7-\delta}$ have demonstrated that x-ray diffraction (XRD) studies can be used to trace even subtle structural phase transitions which are inherently connected with the onset of…
We report variation of lattice structure in diborides (AB2) with different A atoms to identify the special case of MgB2 showing high Tc superconductivity. High purity MgB2 (Tc~39 K) has been prepared by direct reaction of the elements and…
The superconducting phase diagram of MgB2 was determined from magnetization, magneto-transport and the first single-crystal specific heat measurements. A zero-temperature in-plane coherence length of 8 nm is determined. The superconducting…
The distribution of magnetic field in single-phase polycrystalline bulk MgB2 has been measured using a Magneto-Optical (MO) technique for an external magnetic field applied perpendicular to the sample surface. The MO studies indicate that…
Magnetization in DC magnetic fields and at different temperatures have been measured on the Li2Pd3B compound. This material was recently found to show superconductivity at 7-8K. Critical fields Hc1(0) and Hc2(0) have been determined to be…
The upper critical field and flux pinning in MgB2 single crystals were investigated. The implications of these properties for technical applications are discussed and compared with transport properties of polycrystalline bulk samples and…
Hydrogenation of MgB_2 powder has lead to an increase in the superconducting temperature, as determined by ac susceptibility. Applied dc fields reduce the transition temperature in the same ratio as for the pure powder.
Cold high pressure densification (CHPD) is presented as a new way to substantially enhance the critical current density of in situ MgB2 wires at 4.2 and 20 K at fields between 5 and 14 T. The results on two binary MgB2 wires and an alloyed…
We introduce a simple method of an MgB2 film preparation using sequential electron-beam evaporation of B-Mg two-layer (followed by in-situ annealing) on the NbN buffered Si(100) substrate. The Transmission Electron Microscopy analyses…
High quality MgB2 thin films have been obtained by pulsed laser deposition both on MgO and on Al2O3 substrates using different methods. In the standard two-step procedure, an amorphous precursor layer is deposited at room temperature…