Related papers: Thermal effects on atomic friction
We study the velocity dependence of the frictional force of the tip of an atomic force microscope as it is dragged across a surface, taking into account memory effects and thermal fluctuations. Memory effects are described by a coupling of…
We present a theoretical study of the effect of surface defects on atomic friction in the stick-slip dynamical regime of a minimalistic model. We focus on how the presence of defects and temperature change the average properties of the…
The influence of out-of-plane and in-plane contact vibrations and temperature on the friction force acting on a sharp tip elastically pulled on a crystal surface is studied using a generalized Prandtl- Tomlinson model. The average friction…
We present a comparative analysis of the velocity dependence of atomic-scale friction for the Tomlinson model, at zero and finite temperatures, in 1D and 2D, and for different values of the damping. Combining analytical arguments with…
In this work we propose an extension to the analytical one-dimensional model proposed by E. Gnecco (Phys. Rev. Lett. 84:1172) to describe friction. Our model includes normal forces and the dependence with the angular direction of movement…
The influence of lateral vibrations on the stick-slip motion of a nanotip elastically pulled on a flat crystal surface is studied by atomic force microscopy (AFM) measurements on a NaCl(001) surface in ultra-high vacuum. The slippage of the…
Experiments performed by friction force microscopy at atomic-scale surface steps on graphite, MoS$_2$, and NaCl in ambient conditions are presented. Both step-down and step-up scans exhibit higher frictional forces at the edge, but…
Friction is the basic, ubiquitous mechanical interaction between two surfaces that results in resistance to motion and energy dissipation. In spite of its technological and economic significance, our ability to control friction remains…
In this work we present a molecular dynamics simulation of a FFM experiment. The tip-sample interaction is studied by varying the normal force in the tip and the temperature of the surface. The friction force, cA, at zero load and the…
Friction is one of the fundamental issues in physics, mechanics and material science with lots of practical applications. However, the understanding of macroscopic friction phenomena from microscopic aspect is still on the way. In this…
We consider an oscillator model to describe qualitatively friction force for an atomic force mi-croscope (AFM) tip driven on a surface described by periodic potential. It is shown that average value of the friction force could be controlled…
Developing the non-equilibrium thermodynamics of friction is required for systematic design of low friction surfaces for a broad range of technological applications. Intuitively, the thermodynamic work done by a material sliding along a…
We explore dynamic structural superlubricity for the case of a relatively large contact area, where the friction force is proportional to the area (exceeding $\sim 100\,nm^2$) experimentally, numerically, and theoretically. We use a setup…
We study the thermal effects on the frictional properties of atomically thin sheets. We simulate a simple model based on the Prandtl-Tomlinson model that reproduces the layer dependence of friction and strengthening effects seen in AFM…
We present a theoretical study of the dynamics of a tip scanning a graphite surface as a function of the applied load. From the analysis of the lateral forces, we extract the friction force and the corrugation of the effective tip-surface…
The paper investigates friction and friction heat of the micronscale iron under influences of velocity of the slider and temperature of the substrate by using smoothed particle hydrodynamics simulations. In the velocity range of 10 - 100…
Friction is a complicated phenomenon involving nonlinear dynamics at different length and time scales[1, 2]. The microscopic origin of friction is poorly understood, due in part to a lack of methods for measuring the force on a…
Molecular dynamic (MD) simulations are applied to investigate the dependency of the kinetic friction coefficient on the temperature at the nano-scale. The system is comprised of an aluminum spherical particle consisting of 32000 atoms in an…
With use of simulated friction force microscopy, we study the effect of varying temperature on the frictional properties of suspended graphene. In contrast with the theory of thermally activated friction on the surfaces of three-dimensional…
We performed molecular dynamics (MD) experiments to explore dry sliding friction at the nanoscale. We used the setup comprised of a spherical particle built up of 32,000 aluminium atoms, resting on a semi-space with a free surface, modelled…