Related papers: Steady-state mode I cracks in a viscoelastic trian…
We extend the Slepyan solution of the problem of a steady-state crack in an infinite ideally brittle lattice model to include dissipation in the form of Kelvin viscosity. As a demonstration of this technique, based on the Wiener-Hopf…
We study Mode I fracture in a viscoelastic lattice model with a nonlinear force law, with a focus on the velocity and linear stability of the steady-state propagating solution. This study is a continuation both of the study of the…
We present the analytic solution of the Mode III steady-state crack in a square lattice with piecewise linear springs and Kelvin viscosity. We show how the results simplify in the limit of large width. We relate our results to a model where…
We discuss steady state crack growth in the spirit of a free boundary problem. It turns out that mode I and mode III situations are very different from each other: In particular, mode III exhibits a pronounced transition towards unstable…
We study the steady-state motion of mode III cracks propagating on a lattice exhibiting viscoelastic dynamics. The introduction of a Kelvin viscosity $\eta$ allows for a direct comparison between lattice results and continuum treatments.…
In order to study the stability of mode-I fracture, we consider a crack moving along the centerline of a very wide strip and compute its steady-state response to a small, spatially periodic shear stress. We find that, in the presence of…
We study the effect of general nonlinear force laws in viscoelastic lattice models of fracture, focusing on the existence and stability of steady-state Mode III cracks. We show that the hysteretic behavior at small driving is very sensitive…
This paper demonstrates that rapid fracture of ideal brittle lattices naturally involves phenomena long seen in experiment, but which have been hard to understand from a continuum point of view. These idealized models do not mimic realistic…
The fracture toughness for a mode I/II crack propagating in a ductile material has been subject to numerous investigations. However, the influence of the material hardening law has received very limited attention, with isotropic hardening…
For solving the longstanding materials science problem of correlating elastic properties of a solid material to the formation of cracks we present a new general concept. This concept is applied to the technologically most important cracks…
Cracks, the major vehicle for material failure, tend to accelerate to high velocities in brittle materials. In three-dimensions, cracks generically undergo a micro-branching instability at about 40% of their sonic limiting velocity. Recent…
The method of iterated conformal maps is developed for quasi-static fracture of brittle materials, for all modes of fracture. Previous theory, that was relevant for mode III only, is extended here to mode I and II. The latter require…
We discuss the stick-slip motion of an elastic block sliding along a rigid substrate. We argue that for a given external shear stress this system shows a discontinuous nonequilibrium transition from a uniform stick state to uniform sliding…
We study mode-I fracture in lattices with noisy bonds. In contrast to previous attempts, by using a small parameter that perturbs the force-law between the atoms in perfect lattices and using a 3-body force law, simulations reproduce the…
We study two closely related, nonlinear models of a viscoplastic solid. These models capture essential features of plasticity over a wide range of strain rates and applied stresses. They exhibit inelastic strain relaxation and steady flow…
A dynamic crack will travel in a straight path up to a material-dependent critical speed beyond which its path becomes erratic. Predicting this critical speed and discovering the origin of this instability are two outstanding problems in…
Mode-I fracture exhibits microbranching in the high velocity regime where the simple straight crack is unstable. For velocities below the instability, classic modeling using linear elasticity is valid. However, showing the existence of the…
When quickly detaching an elastomer from a counterface, viscoelasticity dramatically increases the perceived adhesion relative to its adiabatic or equilibrium value. Here, we report simulations on the sticking contact between a rigid…
The stability of a rapid dynamic crack in a two dimensional infinite strip is studied in the framework of Linear Elasticity Fracture Mechanics supplemented with a modified principle of local symmetry. It is predicted that a single crack…
We study the dynamics of cracks in brittle materials when the velocity of the crack is comparable to the sound velocity by means of lattice simulations. Inertial and damped dynamics are analyzed. It is shown that dissipation strongly…