Related papers: Dispersion Measure Variations and their Effect on …

We have conducted the largest investigation to date into the origin of phase resolved, apparent RM variations in the polarized signals of radio pulsars. From a sample of 98 pulsars based on observations at 1.4 GHz with the Parkes radio…

Millisecond pulsars are intrinsically very stable clocks and precise measurement of their observed pulse periods can be used to study a wide variety of astrophysical phenomena. In particular, observations of a large sample of millisecond…

In 2018 an ultra-wide-bandwidth low-frequency (UWL) receiver was installed on the 64-m Parkes Radio Telescope enabling observations with an instantaneous frequency coverage from 704 to 4032 MHz. Here, we present the analysis of a three-year…

Data are gathered from the Parkes pulsar data archive of twelve young radio pulsars, with the intervals of data for each pulsar ranged between 2.8 years and 6.8 years. 31 glitches are identified by using phase connection from "pulsar…

In this work, we investigated the presence of strictly periodic, as well as quasi-periodic signals, in the timing of the 25 millisecond pulsars from the EPTA DR2 dataset. This is especially interesting in the context of the recent hints of…

Radio telescopes are used to accurately measure the time of arrival (ToA) of radio pulses in pulsar timing experiments that target mostly millisecond pulsars (MSPs) due to their high rotational stability. This allows for detailed study of…

Solar Orbiter will observe the Sun and the inner heliosphere to study the connections between solar activity, coronal structure, and the origin of the solar wind. The plasma instruments on board Solar Orbiter will determine the…

The survey of northern hemisphere were made at a frequency of 111 MHz. The total accumulation time at each point of the sky was at least one hour. 75 sources of pulse emission were detected. More then 80% of these sources are known pulsars…

The following results of dissertation are submitted for defense: 1. Precise measurements of coordinates and proper motion of the pulsar PSR 0329+54 using the VLBI method. 2. Establishing of the reason for the discrepancy between the…

High-precision pulsar timing is highly dependent on precise and accurate modeling of any effects that impact the data. It was shown that commonly used Solar Wind models do not accurately account for variability in the amplitude of the Solar…

Pulsars are famed for their rotational clock-like stability and their highly-repeatable pulse shapes. However, it has long been known that there are unexplained deviations (often termed "timing noise") from the rate at which we predict…

In-situ observations of magnetic field fluctuations in the solar wind show a broad continuum in the power spectral density (PSD) with a power-law range of scaling often identified as an inertial range of magnetohydrodynamic turbulence.…

The sensitivity of pulsar timing arrays to gravitational waves is, at some level, limited by timing noise. Red timing noise - the stochastic wandering of pulse arrival times with a red spectrum - is prevalent in slow-spinning pulsars and…

Context. Pulsars have a very stable rotation. However, sudden increases in their rotation frequency known as glitches, perturb their evolution. While large glitches are commonly detected, small glitches are harder to detect because of the…

The Parkes 20 cm Multibeam pulsar surveys have discovered nearly half of the known pulsars and revealed many distant pulsars with high dispersion measures. Using a sample of 1,301 pulsars from these surveys, we have explored the spatial…

Recently, there have been reports of six bright, dispersed bursts of coherent radio emission found in pulsar surveys with the Parkes Multi-beam Receiver. Not much is known about the progenitors of these bursts, but they are…

Timing observations of 40 mostly young pulsars using the ATNF Parkes radio telescope between 1990 January and 1998 December are reported. In total, 20 previously unreported glitches and ten other glitches were detected in 11 pulsars. These…

Pulsar timing is a valuable source of high-precision astrophysical measurements which can be used to probe gravitational physics, including by detecting gravitational waves. An important factor limiting the precision of these measurements…

We present initial pulsar results from the first station of the Long Wavelength Array (LWA1) obtained during the commissioning period of LWA1 and early science results. We present detections of periodic emission from 44 previously known…

We calculate detailed modification of pulses from a pulsar arising from the effects of phase transition induced density fluctuations on the pulsar moment of inertia. We represent general statistical density fluctuations using a simple model…