Related papers: Receiver control for the Submillimeter Array
As power systems become more and more interconnected, the inter-area oscillations has become a serious factor limiting large power transfer among different areas. Underdamped (Undamped) inter-area oscillations may cause system breakup and…
We describe here the implementation of an interferometer-based microwave impedance microscope on a home-built tuning-fork based scanning probe microscope (SPM). Tuning-fork based SPMs, requiring only two electrical contacts for…
Rate-splitting multiple access (RSMA) has been studied for multiuser multiple-input multiple-output (MUMIMO) systems especially in the presence of imperfect channel state information (CSI) at the transmitter. However, its precoding designs…
The Murchison Widefield Array (MWA) is an electronically steered low frequency ($<300$\,MHz) radio interferometer, with a `slew' time less than 8seconds. Low frequency ($\sim 100$\,MHz) radio telescopes are ideally suited for rapid-response…
Distributed massive multiple-input multiple-output (MIMO) combines the array gain of coherent MIMO processing with the proximity gains of distributed antenna setups. In this paper, we analyze how transceiver hardware impairments affect the…
The article deals with the development, implementation and research of the spectrum analyzers that can be used in sensor networks and Internet systems of things. As an operating frequency range, 2.4-2.5 GHz ISM is selected. At the stage of…
Rate-Splitting Multiple Access (RSMA) is an emerging flexible, robust and powerful multiple access scheme for downlink multi-antenna wireless networks. RSMA relies on multi-antenna Rate-Splitting (RS) strategies at the transmitter and…
A multi-user cognitive (secondary) radio system is considered, where the spatial multiplexing mode of operation is implemented amongst the nodes, under the presence of multiple primary transmissions. The secondary receiver carries out…
Smart matter consists of many sensors, computers and actuators embedded within materials. These microelectromechanical systems allow properties of the materials to be adjusted under program control. In this context, we study the behavior of…
Integrators are fundamental instruments to recover differential signals from magnetic probes in Experimental Advanced Superconducting Tokamak (EAST) experiments. A kind of difference integrator is introduced which has the same structure as…
The Prime-Cam instrument on the Fred Young Submillimeter Telescope (FYST) is expected to be the largest deployment of millimeter and submillimeter sensitive kinetic inductance detectors to date. To read out these arrays efficiently, a…
A photonic integrated circuit (PIC) comprised of an 11 cm multimode speckle waveguide, a 1x32 splitter, and a linear grating coupler array is fabricated and utilized to receive 2 GHz of radio-frequency (RF) signal bandwidth from 2.5 to 4.5…
Near-field spherical waves inherently encode both direction and distance information, enabling spotlight-like beam focusing for targeted interference mitigation. However, whether such beam focusing can fully eliminate interference under…
The LIGO Interferometer Sensing and Control System (ISC) is a large and highly distributed Multiple Input Multiple Output (MIMO) control system that is used to control the length and alignment degrees of freedom of the interferometers. The…
Here we briefly present some design approaches for a multifrequency 96-antenna radioheliograph. The array antenna configuration, transmission lines and digital receivers are the main focus of this work. The radioheliograph is a T-shaped…
Digital equipment such as computers, telecommunication systems and instruments use microprocessors that operate at high frequencies allowing them to carry out millions or even billions of operations per second. A disturbance in the…
The combination of frequency diverse array (FDA) radar technology with the multiple input multiple output (MIMO) radar architecture and waveform diversity techniques potentially promises a high integration gain with respect to conventional…
Deviations of grid frequency from the nominal frequency are an indicator of the global imbalance between genera- tion and load. Two types of control, a distributed propor- tional control and a centralized integral control, are cur- rently…
Interferometry can measure the shape or the material density of a system that could not be measured otherwise by recording the difference between the phase change of a signal and a reference phase. This difference is always between $-\pi$…
We present a method of spatially mapping microwave kinetic inductance detector (MKID) arrays, in a dark setup. MKIDs are superconducting natively multiplexed resonators which enable kilopixel arrays, such as for the proposed Probe…