Related papers: Coupling Impedances and Heating due to Slots in th…
We present energy spread and bunch length measurements at the Accelerator Test Facility (ATF) at KEK, as functions of current, for different ring rf voltages, and with the beam both on and off the coupling resonance. We fit the on-coupling…
Longitudinal and transverse impedances are derived for round and flat laminated vacuum chambers.
A general derivation of the beam coupling impedances produced by small discontinuities on the wall of the vacuum chamber of an accelerator is reviewed. A collection of analytical formulas for the impedances of small obstacles is presented.
It has been shown that a small discontinuity such as an enlargement or a hole on circular waveguides can produce trapped electromagnetic modes with frequencies slightly below the waveguide cutoff. The trapped modes due to multiple…
The beam coupling impedances of small obstacles protruding inside the vacuum chamber of an accelerator are calculated analytically at frequencies for which the wavelength is large compared to a typical size of the obstacle. Simple formulas…
Knowledge of the electromagnetic interaction between a beam and the surrounding vacuum chamber is necessary in order to optimize the accelerator performance in terms of stored current. Many instability phenomena may occur in the machine…
I describe the use of techniques based on composite rotations to develop controlled phase gates in which the effects of weak Ising couplings are suppressed. A tailored composite phase gate is described which both suppresses weak couplings…
This report presents bunch length and energy spread measurements performed in April 2000 at the ATF Damping Ring, at KEK. Measurements were performed with the beam on and then off the linear (difference) coupling resonance. Due to strong…
The upgrade project of Hefei Light Source storage ring is under way. In this paper, the broadband impedances of resistive wall and coated ceramic vacuum chamber were calculated using the analytic formula, the wake fields and impedances of…
There is a clear discrepancy among the energy-gap values for different 90 K cuprates, inferred from tunneling measurements. By using the phase diagram for hole-doped cuprates we show that tunneling measurements performed on 90 K cuprates,…
In particle accelerators, pumping holes in a vacuum chamber can be a source of unwanted broadband coupling impedance, leading to beam instabilities. Analytical methods have been previously developed to estimate the impedance of holes in…
We study the dissipation in a system consisting of a small metallic island coupled to a gate electrode and to a massive reservoir via single tunneling junction. The dissipation of energy is caused by a slowly oscillating gate voltage. We…
Low frequency AC-measurements are commonly used to determine the voltage and currents through mesoscopic devices. We calculate the effect of the alternating Hall voltage on the recorded time-averaged voltage in the presence of a top-gate…
A general theory of the beam interaction with small discontinuities of the vacuum chamber is developed taking into account the reaction of radiated waves back on the discontinuity. The reactive impedance calculated earlier is reproduced as…
The beam coupling impedances of small axisymmetric obstacles having a semi-elliptical cross section along the beam in the vacuum chamber of an accelerator are calculated at frequencies for which the wavelength is large compared to a typical…
We use a method of matched asymptotics to determine the energy gap of two counter-propagating, strongly interacting, quantum Hall edge states. The microscopic edge state dispersion and Coulomb interactions are used to precisely constrain…
The beam coupling impedances of small discontinuities of an accelerator vacuum chamber have been calculated [e.g., S.S. Kurennoy, R.L. Gluckstern, and G.V. Stupakov, Phys. Rev. E 52, 4354 (1995)] for ultrarelativistic beams using the Bethe…
The transversal and longitudinal resistance in the quantum Hall effect regime was measured in a Si MOSFET sample in which a slot-gate allows one to vary the electron density and filling factor in different parts of the sample. In case of…
We discuss the quantum mechanics of B-factory experiments, and that of neutral K or B decay. Predictions for the processes to be studied at the B factories can be made through an approach based on amplitudes, rather than on wave functions.…
By modelling heat engines as driven multi-partite system we show that their dissipation can be expressed in terms of the lag (relative entropy) between the perturbed state of each partition and their equilibrium state, and the correlations…