Related papers: Radio-frequency reflectometry in silicon carbide l…
We report the development of a cryogenic powder filter that simultaneously offers high attenuation of radio-frequency (RF) signals in the gigahertz (GHz) range and minimized parasitic capacitance to ground. Conventional powder filters,…
Nonreciprocal microwave devices, such as circulators and isolators, are needed in high-fidelity qubit readout schemes to unidirectionally route the readout signals and protect the qubits against noise coming from the output chain. However,…
We explain why a system of cold $^{85}Rb$ atoms at temperatures of the order $T\approx 7.78\times 10^{-5}$ K and below, but not too low to lie in the quantum reflection regime, should be automatically repelled from the surface of a…
The latest generation of transistors are nanoscale devices whose performance and reliability are limited by thermal noise in low-power applications. Therefore developing efficient methods to compute the voltage and current fluctuations in…
Two-dimensional materials (2DMs) are a promising alternative to complement and upgrade high-frequency electronics. However, in order to boost their adoption, the availability of numerical tools and physically-based models able to support…
By operating the radio frequency single electron transistor (rf-SET) as a mixer we present measurements in which the RC roll-off of the tunnel junctions is observed at high frequencies. Our technique makes use of the non-linear rf-SET…
Temperature-based radiation detectors are an essential tool for long optical wavelengths detection even if they often suffer from important bandwidth limitations. Their responsivity, and hence their noise equivalent power (NEP), typically…
We demonstrate the sensitivity of a sensor based on an optically-pumped radio-frequency (RF) atomic magnetometer to the polarization state of the detected RF magnetic field, and measure $>$36 dB difference in amplitude sensitivity for…
A novel resonant method based on a tunnel-diode oscillator (TDO) is used to study the dynamic transverse susceptibility in a Fe nanoparticle system. The magnetic system consists of an aggregate of nanometer-size core (Au)-shell (Fe)…
We report fast, simultaneous charge sensing and transport measurements of gate-defined carbon nanotube quantum dots. Aluminum radio frequency single electron transistors (rf-SETs) capacitively coupled to the nanotube dot provide…
The electron fluid model in plasmonic field effect transistor (FET) operation is related to the behavior of a radio-frequency (RF) cavity. This new understanding led to finding the relationships between physical device parameters and…
We have developed a microspectroscopy technique for measuring gate-modulated reflectance to probe excitonic states in two-dimensional transition metal dichalcogenides. Successfully observing excited states of excitons from cryogenic to room…
We report on highly tunable radio frequency (rf) characteristics of a low-loss and compact three dimensional (3D) metamaterial made of superconducting thin film spiral resonators. The rf transmission spectrum of a single element of the…
Integrating nano-scale objects, such as single molecules or carbon nanotubes, into impedance transformers and performing radio-frequency measurements allows for high time-resolution transport measurements with improved signal-to-noise…
Self-heating in surrounding gate transistors can degrade its on-current performance and reduce lifetime. If a transistor heats/cools with time-constants less than the inverse of the operating frequency, a predictable, frequency-independent…
The paper describes a radio frequency (RF) spectrometer for 14N nuclear quadrupole resonance (NQR) spectroscopy that uses a detector coil cooled to 77 K to maximize measurement sensitivity. The design uses a minimally-intrusive network of…
On-chip THz spectroscopy enables quantitative measurements of the optical conductivity of sub-wavelength 2D materials by tightly confining THz fields in metallic transmission line structures interfaced to the material. However, because the…
The future 5G networks are expected to use millimeter wave (mmWave) frequency bands, mainly due to the availability of large unused spectrum. However, due to high path loss at mmWave frequencies, coverage of mmWave signals can get severely…
Current quantum computing platforms suffer from readout errors, where faulty measurement outcomes are reported by the device. These errors are particularly harmful in quantum programs that rely on branch statements wherein operations in…
Polarized neutron reflectometry is used to study the magnetic proximity effect in a superconductor/ferromagnet (SC/FM) system of composition Cu(32nm)/V(40nm)/Fe(1nm)/MgO. In contrast to previous studies, here a single SC/FM bilayer, is…