Related papers: 236 {\mu}W Direct-RF PLL-Free Multi-PSK Transmitte…
In most digital-to-time converter (DTC) based applications, apart from maintaining low integral non-linearity (INL), it is also required of the system to achieve a wide frequency translation range. To achieve this performance, we present a…
Traditional wireless power transfer (WPT) systems are largely limited to 1-D charging pads or 2-D charging surfaces and therefore do not support a truly ubiquitous device-powering experience. Although room-scale WPT based on multimode…
We consider a grid-connected voltage source converter (VSC) and address the problem of estimating the grid angle and frequency, information that is essential for an appropriate operation of the converter. We design phase-locked loop (PLL)…
Short packets make channel learning expensive. In pilot-aided transmission (PAT), a non-negligible fraction of the packet is consumed by pilots, creating a direct pre-log loss and tightening the reliability margin needed for ultra-reliable…
This paper proposes an active radio frequency (RF) cancellation solution to suppress the transmitter (TX) passband leakage signal in radio transceivers supporting simultaneous transmission and reception. The proposed technique is based on…
Terahertz bands enable ultra-broadband wireless communications but require compact, low-cost, and efficient transceiver modules. Conventional implementations based on metallic waveguides or silicon lenses suffer from high loss, bulkiness,…
In this paper, we study THz simultaneous wireless information and power transfer (SWIPT) systems. Since coherent information detection is challenging at THz frequencies and Schottky diodes may not be efficient for THz energy harvesting (EH)…
A clock synchronizing circuit for repeaterless low swing interconnects is presented in this paper. The circuit uses a delay locked loop (DLL) to generate multiple phases of the clock, of which the one closest to the center of the eye is…
A three-cell 1.3 GHz, Normal Conducting (NC) buncher is designed for a possible future upgrade of the European XFEL to operate in a continuous-wave (CW) / long pulse (LP) mode. The RF geometry of the buncher is optimized for high shunt…
Active photonic integrated circuits (PICs) in the visible spectrum are essential for on-chip applications, requiring low-loss waveguides with broad transparency and efficient, low-power phase modulation. Here, we demonstrate a compact,…
This paper presents a high linearity PAM-4 transmitter (TX) architecture, consisting of a three-segment micro-ring modulator (MRM) and a matched CMOS driver. This architecture can drive a high-linearity 4-level pulse amplitude (PAM-4)…
Compact, non-volatile optical switches on silicon platforms are essential for reconfigurable photonics, but the strong anisotropy of silicon waveguides leads to polarization-dependent performance. In this paper, we propose a…
A near-field simultaneous wireless information and power transfer (SWIPT) network is investigated, where the hybrid beamforming architecture is employed at the base station (BS) for information transmission while charging energy harvesting…
In this work, a novel highly fabrication tolerant polarization beam splitter (PBS) is presented on an InP platform. To achieve the splitting, we combine the Pockels effect and the plasma dispersion effect in a symmetric 1x2 Mach-Zehnder…
In silicon electro-optic (EO) Mach-Zehnder interferometer (MZI) switches, crosstalk is typically limited by beam imbalance between the MZI arms, primarily caused by the free carrier absorption loss during routing, thus hindering switch…
A broadband silicon polarization beam splitter (PBS) is proposed and experimentally demonstrated based on Floquet-engineered directional couplers. The total length of the coupling structure is 20 um . By periodically modulating the…
In this paper, a highly-efficient single-switch-regulated resonant wireless power receiver with hybrid modulation is proposed. To achieve both high efficiency and good output voltage regulation, phase shift and pulse width hybrid modulation…
We consider communication over the block noncoherent AWGN channel with low-precision Analog-to-Digital Converters (ADCs) at the receiver. For standard uniform Phase Shift Keying (PSK) modulation, we investigate the performance of a receiver…
A 33.6 ps LSB Time-to-Digital converter was designed in 130 nm BiCMOS technology. The core of the converter is a differential 9-stage ring oscillator, based on a multi-path architecture. A novel version of this design is proposed, along…
Efficient RF power amplifiers used in third generation systems require linearization in order to reduce adjacent channel inter-modulation distortion, without sacrificing efficiency. Digital baseband predistortion is a highly cost-effective…