Related papers: Competing Constraints on Superconductivity in Thic…
Stabilized FeSe thin films in ambient pressure with tunable superconductivity would be a promising candidate for superconducting electronic devices yet its superconducting transition temperature (Tc) is below 10 K in bulk materials. By…
We performed systematic studies on the transport properties of FeSe thin films with controlled degrees of in-plane lattice strain, including both tensile and compressive strains. The superconducting transition temperature, $T_{\mathrm c}$,…
There is an ongoing debate about the relative importance of structural change versus doping charge carriers on the mechanism of superconductivity in Fe-based materials. Elucidating this issue is a major challenge since it would require a…
The films of FeSe on substrates have attracted attention because of their unusually high-temperature (Tc) superconducting properties whose origins continue to be debated. To disentangle the competing effects of the substrate and interlayer…
In order to investigate the effects of in-plane strain on the superconductivity of FeSe, epitaxial thin films of FeSe were fabricated on CaF$_2$ substrates. The films are compressed along the a-axis and their superconducting transition…
Superconductivity was recently found in the simple tetragonal FeSe structure. Recent studies suggest that FeSe is unconventional, with the symmetry of the superconducting pairing state still under debate. To tackle these problems, clean…
In this study, we fabricate 5-30-nm-thick films of FeSe/STO using pulsed laser deposition (PLD). The grown films exhibit superconductivity with an onset $T_{\mathrm{c}}$ that is much higher than that of bulk FeSe under ambient pressure. The…
We demonstrate the successful fabrication on CaF$_2$ substrates of FeSe$_{1-x}$Te$_{x}$ films with $0 \le x \le 1$, including the region of $0.1 \le x \le 0.4$, which is well known to be the "phase-separation region", via pulsed laser…
Epitaxial Fe(Se,Te) thin films were prepared by pulsed laser deposition on (La0.18Sr0.82)(Al0.59Ta0.41)O3 (LSAT), CaF2-buffered LSAT and bare CaF2 substrates, which exhibit an almost identical in-plane lattice parameter. The composition of…
We report the successful growth of epitaxial thin films of FeSe$_{1-x}$S$_x$ with $x \leq 0.43$ via pulsed laser deposition. As S content increases, the nematic transition temperature, $T_{\mathrm s}$, decreases systematically and the…
In contrast to its bulk crystals, the FeSe film or layer exhibits better superconductivity performance, which attract much interest in its fundamental research as well as potential application. In present work, transition from insulator to…
The record of superconducting transition temperature(Tc) has long been 56K for the iron-based high temperature superconductors(Fe-HTS's). Recently, in single layer FeSe films grown on SrTiO3 substrate, signs for a new 65K Tc record are…
Interface enhanced superconductivity at two dimensional limit has become one of most intriguing research directions in condensed matter physics. Here, we report the superconducting properties of ultra-thin FeSe films with the thickness of…
The discovery of superconductivity (SC) with a transition temperature, Tc, up to 65K in single-layer FeSe (bulk Tc =8K) films grown on SrTiO3 substrates has attracted special attention to Fe-based thin films. The high Tc is a consequence of…
Thin film growth of iron chalcogenides by pulsed laser deposition (PLD) is still a delicate issue in terms of simultaneous control of stoichiometry, texture, substrate/film interface properties, and superconducting properties. The high…
We have fabricated high-quality FeSe1-x superconducting films with a bulk Tc of 11-12 K on different substrates, Al2O3(0001), SrTiO3(100), MgO(100), and LaAlO3(100), by using a pulsed laser deposition technique. All the films were grown at…
Recently, interface has been employed to enhance superconductivity in the single-layer FeSe films grown on SrTiO3(001)(STO) with a possible Tc of ~ 80 K, which is nearly ten times of the Tc of bulk FeSe and is above the Tc record of 56 K…
Interface-enhanced high-temperature superconductivity in one unit-cell (UC) FeSe film on SrTiO3(001) (STO) substrate has recently attracted much attention in condensed matter physics and material science. Here, by ex situ transport…
We have studied the effect of tensile strain on the superconductivity in FeSe films. 50 nm, 100 nm, and 200 nm FeSe films were grown on MgO, SrTiO$_3$, and LaAlO$_3$ substrates by using a pulsed laser deposition technique. X-ray diffraction…
We have investigated the crystal structures and superconducting properties of thin films of FeSe$_{0.5}$Te$_{0.5}$ grown on eight different substrates. Superconductivity is not correlated with the lattice mismatch; rather it is correlated…