Related papers: Clock Noise Cancellation in Heterodyne Links betwe…
Space gravitational wave detectors employing laser interferometry between free-flying spacecraft differ in many ways from their laboratory counterparts. Among these differences is the fact that, in space, the end-masses will be moving…
Heterodyne laser phase measurements in a space-based gravitational wave interferometer are degraded by the phase fluctuations of the onboard clocks, resulting in unacceptable sensitivity performance levels of the interferometric data. In…
Direct observations of gravitational waves at frequencies below 10 Hz will play crucial roles for fully exploiting the potential of gravitational wave astronomy. One approach to pursue this direction is the utilization of laser…
In this work, we have built an experimental setup to simulate the clock noise transmission with two spacecrafts and two optical links, and further demonstrated the extraction of picometer level signal drowned by the large laser frequency…
The ongoing development of the space-based laser interferometer missions is aiming at unprecedented gravitational wave detections in the millihertz frequency band. The spaceborne nature of the experimental setups leads to a degree of…
The DECi-hertz Interferometer Gravitational-wave Observatory (DECIGO) is a planned space-based, next-generation gravitational wave detector aimed at observing primordial gravitational waves originating form cosmic inflation. This work…
The back-linked Fabry-Perot interferometer (BLFPI) is an interferometer topology proposed for space gravitational wave antennas with the use of inter-satellite Fabry-Perot interferometers. The BLFPI offers simultaneous and independent…
This paper reports an experimental demonstration of partial displacement noise free laser interferometry in the gravitational wave detection band. The used detuned Fabry-Perot cavity allows the isolation of the mimicked gravitational wave…
We estimate the sensitivity to nano-Hertz gravitational waves of pulsar timing experiments in which two highly-stable millisecond pulsars are tracked simultaneously with two neighboring radio telescopes that are referenced to the same…
Interferometers with kilometer-scale arms have been built for gravitational-wave detections on the ground; ones with much longer arms are being planned for space-based detection. One fundamental motivation for long baseline interferometry…
A crucial challenge to the ongoing endeavor of spaceborne gravitational wave (GW) detection resides in the laser phase noise, typically 7 to 8 orders of magnitude above the inevitable noise. The arm locking technique was proposed to…
The Laser Interferometer Space Antenna (LISA) is a European Space Agency mission that aims to measure gravitational waves in the millihertz range. The three-spacecraft constellation forms a nearly-equilateral triangle, which experiences…
The DECi-hertz Interferometer Gravitational wave Observatory (DECIGO) is designed to detect gravitational waves at frequencies between 0.1 and 10 Hz. In this frequency band, one of the most important science targets is the detection of…
Space-borne gravitational wave detection will open the observation window in the 0.1 mHz$-$1 Hz bandwidth, playing a crucial role in the development of cosmology and physics. Precise clock synchronization among satellites is essential for…
We present a noise estimation and subtraction algorithm capable of increasing the sensitivity of heterodyne laser interferometers by one order of magnitude. The heterodyne interferometer is specially designed for dynamic measurements of a…
We present a bidirectional internal squeezing scheme for gravitational-wave detectors and show that it saturates the lowest known lower bounds on quantum noise from internal optical dissipation. The scheme uses two optical parametric…
The second generation of interferometric gravitational wave detectors are quickly approaching their design sensitivity. For the first time these detectors will become limited by quantum back-action noise. Several back-action evasion…
We consider improving the sensitivity of future interferometric gravitational-wave detectors by simultaneously injecting two squeezed vacuums (light), filtered through a resonant Fabry-Perot cavity, into the dark port of the…
Quantum locking using optical spring and homodyne detection has been devised to reduce quantum noise that limits the sensitivity of DECIGO, a space-based gravitational wave antenna in the frequency band around 0.1 Hz for detection of…
Quantum noise limits the sensitivity of precision measurement devices, such as laser interferometer gravitational-wave observatories and axion detectors. In the shot-noise-limited regime, these resonant detectors are subject to a trade-off…