Related papers: Network-Controlled Repeaters Under Power Amplifier…
Recently, the so-called cell-free Massive MIMO architecture has been introduced, wherein a very large number of distributed access points (APs) simultaneously and jointly serve a much smaller number of mobile stations (MSs). A variant of…
This letter studies the energy-efficient design in a downlink multi-antenna multi-user system consisting of a multi-antenna base station (BS) and multiple single-antenna users, by considering the practical non-linear power amplifier (PA)…
This paper investigates the fundamental tradeoff between reconfigurable intelligent surfaces (RISs) and network-controlled repeaters (NCRs) in terms of achievable signal-to-noise ratio (SNR). Considering an uplink system with a…
Massive MIMO requires a large number of antennas and the same amount of power amplifiers (PAs), one per antenna. As opposed to 4G base stations, which could afford highly linear PAs, next-generation base stations will need to use…
In future cell-free (or cell-less) wireless networks, a large number of devices in a geographical area will be served simultaneously in non-orthogonal multiple access scenarios by a large number of distributed access points (APs), which…
Extremely large aperture arrays (ELAAs) and reconfigurable intelligent surfaces (RISs) are candidate enablers to realize connectivity goals for the sixth-generation (6G) wireless networks. For instance, ELAAs can provide orders-of-magnitude…
This paper proposes a tractable solution for integrating non-orthogonal multiple access (NOMA) into massive machine-type communications (mMTC) to increase the uplink connectivity. Multiple transmit power levels are provided at the user end…
In this letter, we study the impact of nonlinear high power amplifier (HPA) on simultaneous wireless information and power transfer (SWIPT), for a point-to-point multiple-input multiple-output communication system. We derive the rate-energy…
Co-channel interference poses a challenge in any wireless communication network where the time-frequency resources are reused over different geographical areas. The interference is particularly diverse in cell-free massive multiple-input…
Network-controlled repeaters (NCR) and reconfigurable intelligent surfaces (RIS) are being considered by the third generation partnership project (3GPP) as valid candidates for range extension in millimeter-wave (mmW, 30-300 GHz frequency)…
Adaptive Power Allocation (PA) algorithms with different criteria for a cooperative Multiple-Input Multiple-Output (MIMO) network equipped with Distributed Space-Time Coding (DSTC) are proposed and evaluated. Joint constrained optimization…
Contemporary wireless communication systems rely on Multi-User Multiple-Input Multiple-Output (MU-MIMO) techniques. In such systems, each Access Point (AP) is equipped with multiple antenna elements and serves multiple devices…
Non-orthogonal multiple access (NOMA) has become a promising technology for next-generation wireless communications systems due to its capability to provide access for multiple users on the same resource. In this paper, we consider an…
Precoding design for the downlink of multiuser multiple-input multiple-output (MU-MIMO) systems is a fundamental problem. In this paper, we aim to maximize the weighted sum rate (WSR) while considering both quality-of-service (QoS)…
Signal clipping is a classic technique for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems. It has been widely applied in consumer electronic devices owing to its low complexity and…
Research has shown that communications systems and receivers suffer from high power adjacent channel signals, called blockers, that drive the radio frequency (RF) front end into nonlinear operation. Since simple systems, such as the…
Reconfigurable antennas (RAs) utilize the electromagnetic (EM) domain to provide dynamic control over antenna radiation patterns, which offers an effective way to enhance power efficiency in wireless links. Unlike conventional arrays with…
In this paper, we investigate downlink power control in massive multiple-input multiple-output (MIMO) networks with distributed antenna arrays. The base station (BS) in each cell consists of multiple antenna arrays, which are deployed in…
In this paper,we investigate a novel wireless powered mobile edge computing (MEC) system assisted by pinching antennas (PAs), where devices first harvest energy from a base station and then offload computation-intensive tasks to an MEC…
Reconfigurable Intelligent Surfaces (RIS) are a new paradigm which, with judicious deployment and alignment, can enable more favorable propagation environments and better wireless network design. As such, they can offer a number of…