Related papers: Network-Controlled Repeaters Under Power Amplifier…
In future B5G/6G broadband communication systems, non-linear signal distortion caused by the impairment of transmit power amplifier (PA) can severely degrade the communication performance, especially when uplink users share the wireless…
We introduce a framework for linear precoder design over a massive multiple-input multiple-output downlink system in the presence of nonlinear power amplifiers (PAs). By studying the spatial characteristics of the distortion, we demonstrate…
Massive multiple input multiple output (MIMO) systems are typically designed under the assumption of linear power amplifiers (PAs). However, PAs are typically most energy-efficient when operating close to their saturation point, where they…
This letter analyzes the effects of power amplifiers (PAs) on the downlink of cell-free massive MIMO systems. We model signal transmission incorporating nonlinear PA distortion and derive a unified spectral efficiency (SE) expression…
Massive multiple-input multiple-output (mMIMO) has been the core of 5G due to its ability to improve spectral efficiency and spatial multiplexing significantly; however, cell-edge users still experience performance degradation due to…
Real-world wireless transmitter front-ends exhibit certain nonlinear behavior, e.g., signal clipping by a Power Amplifier (PA). Although many resource allocation solutions do not consider this for simplicity, it leads to inaccurate results…
Massive MIMO systems are typically designed assuming linear power amplifiers (PAs). However, PAs are most energy efficient close to saturation, where non-linear distortion arises. For conventional precoders, this distortion can coherently…
Integrating sensing capabilities into existing massive MIMO communication networks has become crucial, stemming from a need for a more interconnected society. Improved coverage and performance can be obtained by incorporating new network…
M-MIMO is one of the crucial technologies for increasing spectral and energy efficiency of wireless networks. Most of the current works assume that M-MIMO arrays are equipped with a linear front end. However, ongoing efforts to make…
Large array systems use a massive number of antenna elements and clever precoder designs to achieve an array gain at the user location. These precoders require linear front-ends, and more specifically linear power amplifiers (PAs), to avoid…
This paper introduces a new efficient autoprecoder (AP) based deep learning approach for massive multiple-input multiple-output (mMIMO) downlink systems in which the base station is equipped with a large number of antennas with…
To address the need of coverage enhancement in the fifth generation (5G) of wireless cellular telecommunications, while taking into account possible bottlenecks related to deploying fiber based backhaul (e.g., required cost and time), the…
Due to the nonlinearity of power amplifiers (PAs), the transmit signal is distorted. Previous works have studied the spatial distribution of this distortion for a central massive MIMO array. In this work, we extend the analysis for…
The conventional power allocation strategy via water-filling relies on the premise that the power amplifier (PA) operates sufficiently below saturation such that a linear RF chain model holds. This work integrates the PA nonlinearity…
We present a framework for joint amplification and phase shift optimization of the repeater gain in dynamic time-division duplex (TDD) repeater-assisted massive MIMO networks. Repeaters, being active scatterers with amplification and phase…
In fifth generation (5G) wireless cellular networks, millimeter wave spectrum opens room for several potential improvements in throughput, reliability, latency, among other aspects. However, it also brings challenges, such as a higher…
This paper presents a framework for target detection and downlink data transmission in a repeater-assisted bi-static integrated sensing and communication system. A repeater is an active scatterer that retransmits incoming signals with a…
This paper investigates the uplink capacity of single-input single-output (SISO) systems assisted by a swarm of network-controlled repeaters (NCRs). We develop a rigorous wideband formulation based on OFDM signaling. Starting from the…
Massive multiple-input multiple-output (MIMO) has enabled substantial spatial multiplexing and array gains in real-world systems, while distributed MIMO (D-MIMO) improves macro-diversity over wide areas at the cost of deployment complexity.…
Large array-based transmission uses the combination of a massive number of antenna elements and clever precoder designs to achieve array gain and spatially multiplex different users. These precoders require linear front-ends, and more…