Related papers: PLL Based Sub-/Super-synchronous Resonance Damping…
Considerable efforts have been made to address the resonance issue of the Direct-drive Permanent Magnet Synchronous Generator (D-PMSG) wind farm integrated power systems. However, the D-PMSG controller structure and parameters are concealed…
In a phase-locked loop (PLL) synchronized inverter, due to the strong nonlinear coupling between the PLL's parame-ters and the operation power angle, the equivalent damping coefficient will quickly deteriorate while the power angle is close…
Grid-interactive power converters are normally synchronized to the grid using phase-locked loops (PLLs). The performance of the PLLs is affected by the non-ideal conditions in the sensed grid voltage such as harmonics, frequency deviations…
Differing from synchronous generators, there are lack of physical laws governing the synchronization dynamics of voltage-source converters (VSCs). The widely used phase-locked loop (PLL) plays a critical role in maintaining the synchronism…
We consider a grid-connected voltage source converter (VSC) and address the problem of estimating the grid angle and frequency, information that is essential for an appropriate operation of the converter. We design phase-locked loop (PLL)…
Fluctuations in phase angle and frequency under large disturbances can lead to loss of synchronism (LOS) in grid-following (GFL) converters. The power angle and frequency of synchronous generators (SGs) correspond to rotor position and…
Deploying synchronous condensers (SynCons) near grid-following renewable energy sources (GFLRs) is an effective and increasingly adopted strategy for grid support. However, the potential transient instability risks in such configurations…
Synchronous reference frame phase-looked loop (SRF-PLL) techniques are widely used for interfacing and control applications in the power systems and energy conversion at large. Since a PLL system synchronizes its output with an exogenous…
Subsynchronous oscillations (SSOs) involving grid-following converters (GFLCs) connected to weak grids are a relatively new phenomena observed in modern power systems. SSOs are further exacerbated when grids become weaker because lines are…
It is well-established that a proportional current control gain emulates a resistor in the converter output impedance. Even though this resistance can provide additional damping to grid resonances, its effect for traditional linear current…
The phase-locked loop (PLL) used in the doubly fed induction generator (DFIG) can cause frequency coupling phenomena, which will give negative resistance characteristics ofthe DFIG at low frequency, resulting in stability issues under weak…
In most digital-to-time converter (DTC) based applications, apart from maintaining low integral non-linearity (INL), it is also required of the system to achieve a wide frequency translation range. To achieve this performance, we present a…
This paper presents a novel strategy for the synchronization of grid-following Voltage Source Converters (VSCs) in power systems with low rotational inertia. The proposed synchronization unit is based on emulating the physical properties of…
Clock generation is an essential part of wireless or wireline communication modules. To facilitate recent advancements in wireline-like communication and in-sensor computing modules at relatively lower data rates, ultra-low power, and…
This paper derives closed-form solutions for grid-forming converters with power synchronization control (PSC) by subtly simplifying and factorizing the complex closed-loop models. The solutions can offer clear analytical insights into…
The Grid-Forming Inverter (GFMI) is an emerging topic that is attracting significant attention from both academic and industrial communities, particularly in the area of control design. The Decoupled Average Model-based Sliding Mode Current…
This paper presents a novel deep reinforcement learning (DRL)-based control strategy for achieving precise and robust output voltage regulation in LCC-S resonant converters, specifically designed for wireless power transfer applications.…
Controlling inter-area oscillation (IAO) across wide areas is crucial for the stability of modern power systems. Recent advances in deep learning, combined with the extensive deployment of phasor measurement units (PMUs) and generator…
The presented paper introduces a design for a phase-locked loop (PLL) that is utilized in frequency synthesis and modulation-demodulation within communication systems and in VLSI applications. The CMOS PLL is designed using 180 nm…
Permanent Magnet Synchronous Motors (PMSMs) are widely employed in high-performance drive systems owing to their high efficiency and power density. However, nonlinear dynamics, parameter uncertainties, and load disturbances complicate their…