Related papers: Gaussian Phase Noise Effects on Hybrid Precoding M…

This letter investigates phase noise (PN) mitigation in generalized receiver spatial modulation (GRSM) massive MIMO systems at mmWave under a common local oscillator (CLO). Under CLO, the received energy remains invariant relative to the…

Energy efficiency (EE) optimization of millimeter wave (mm-Wave) massive multiple-input multiple-output (MIMO) systems is emerging as an important challenge for the fifth generation (5G) mobile communication systems. However, the power of…

Phase noise (PN) is a major disturbance in MIMO systems, where the contribution of different oscillators at the transmitter and the receiver side may degrade the overall performance and offset the gains offered by MIMO techniques. This is…

Cell-Free massive MIMO networks provide huge power gains and resolve inter-cell interference by coherent processing over a massive number of distributed instead of co-located antennas in access points (APs). Cost-efficient hardware is…

Terahertz (THz) communication is considered one of the most critical technologies for 6G because of its abundant bandwidth. To compensate the high propagation of THz, analog/digital hybrid precoding for THz massive multiple input multiple…

As the demand for 6G technologies continues to grow, the radio access infrastructure is expected to become increasingly dense. Cell-free (CF) Massive MIMO systems provide remarkable flexibility by enabling coherent service to users through…

The large beamforming gain used to operate at millimeter wave (mmWave) frequencies requires obtaining channel information to configure hybrid antenna arrays. Previously proposed wideband channel estimation strategies, however, assume…

This work encompasses Rate-Splitting (RS), providing significant benefits in multi-user settings in the context of huge degrees of freedom promised by massive Multiple-Input Multiple-Output (MIMO). However, the requirement of massive MIMO…

The massive multiple-input multiple-output (MIMO) transmission technology has recently attracted much attention in the non-geostationary, e.g., low earth orbit (LEO) satellite communication (SATCOM) systems since it can significantly…

In massive multiple-input multiple-output (MIMO) systems, achieving high spectral efficiency (SE) often requires advanced precoding algorithms whose complexity scales rapidly with the number of antennas, limiting practical deployment. In…

The hybrid analog/digital architecture that connects a limited number of RF chains to multiple antennas through phase shifters could effectively address the energy consumption issues in massive multiple-input multiple-output (MIMO) systems.…

Massive MIMO systems are typically designed assuming linear power amplifiers (PAs). However, PAs are most energy efficient close to saturation, where non-linear distortion arises. For conventional precoders, this distortion can coherently…

The application of hybrid precoding in millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems has been proved effective for reducing the number of radio frequency (RF) chains. However, the maximum number of independent data…

In wideband sub-Terahertz (sub-THz) massive multiple-input multiple-output (MIMO) communication systems, the beam squint effect manifests as a substantial degradation in array gain. To mitigate the aforementioned beam squint effect, a…

It is known that phase noise (PN) can cause link performance to degrade severely in orthogonal frequency division multiplexing (OFDM) systems, such as IEEE 802.11, 3GPP LTE and 5G. As opposed to prior PN mitigation schemes that assume…

The high energy consumption of massive multi-input multi-out (MIMO) system has become a prominent problem in the millimeter wave(mm-Wave) communication scenario. The hybrid precoding technology greatly reduces the number of radio…

Quantum Noise Characterization (QNC) is indispensable for benchmarking and mitigating errors in Noisy Intermediate-Scale Quantum (NISQ) devices. However, traditional Quantum Process Tomography (QPT) suffers from an exponential parameter…

Due to the high cost and low energy efficiency of the dedicated radio frequency (RF) chains, the number of RF chains in a millimeter wave (mmWave) multiple-input multiple-output (MIMO) system is usually limited from a practical point of…

For future wireless communication technologies, an increase in capabilities such as throughput is strongly expected. Transmission in the sub-THz bands (>90 GHz) seems to be the potential solution to meet the ever-increasing capacity demands…

This paper investigates the hybrid precoding design for millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems with finite-alphabet inputs. The precoding problem is a joint optimization of analog and digital precoders, and…