Related papers: MgB$_2$ Thermal Kinetic Inductance Detector

The response of superconducting pair-breaking detectors is dependent on the details of the quasiparticle distribution. In Kinetic Inductance Detectors (KIDs), where both pair breaking and non-pair breaking photons are absorbed…

We investigate the operation of WSi superconducting nanowire single-photon detectors (SNSPDs) at 2.5 K, a temperature which is ~ 70 % of the superconducting transition temperature (TC) of 3.4 K. We demonstrate saturation of the system…

If driven sufficiently strongly, superconducting microresonators exhibit nonlinear behavior including response bifurcation. This behavior can arise from a variety of physical mechanisms including heating effects, grain boundaries or weak…

We present a detailed simulation and design framework for realizing traveling wave parametric amplifiers (TWPAs) using the nonlinear kinetic inductance of disordered superconductors -- in our case niobium-titanium-nitride (NbTiN). These…

Modifying phonon thermal conductivity in nanomaterials is important not only for fundamental research but also for practical applications. However, the experiments on tailoring the thermal conductivity in nanoscale, especially in…

The lattice thermal conductivity ($\kappa$) of two ceramic materials, cerium dioxide (CeO$_2$) and magnesium oxide (MgO), is computed up to 1500 K using first principles and the phonon Boltzmann Transport Equation (PBTE) and compared to…

Suspended monolayer transition metal-dichalcogenides (TMD) are membranes that combine ultra-low mass and exceptional optical properties, making them intriguing materials for opto-mechanical applications. However, the low measured quality…

We have fabricated Transition Edge Sensors (TESs) whose thermal characteristics are completely characterised by few-mode ballistic phonon exchange with the heat bath. These TESs have extremely small amorphous SiNx support legs: 0.2 um…

The Lumped Element Kinetic Inductance Detectors (LEKID)demonstrated full maturity in the NIKA (New IRAM KID Arrays)instrument. These results allow directly comparing LEKID performance with other competing technologies (TES, doped silicon)…

Selected for the next generation of adaptive optics (AO) systems, the pyramid wavefront sensor (PWFS) is recognised for its closed AO loop performance. As new technologies are emerging, it is necessary to explore new methods to improve it.…

We present the performance of a superconducting nanowire that can be operated in two detection modes: i) as a kinetic inductance detector (KID) or ii) as a single-photon detector (SPD). Two superconducting nanowires developed for use as…

The discovery of superconductivity in the quantum critical Kondo-lattice system YbRh2Si2 at an extremely low temperature of 2 mK has inspired efforts to perform high-resolution electrical resistivity measurements down to this temperature…

We measure the effect of ionizing radiation on superconducting qubits with a timing resolution of 1 $\mu s$ using microwave kinetic inductance detectors (MKIDs) fabricated on the same substrate. We observe no correlation between two-level…

Astronomical observations of cosmic sources in the far-infrared and X-ray bands require extreme sensitivity. The most sensitive detectors are cryogenic bolometers and calorimeters operating typically at about 100 mK. The last stage of…

Microwave Kinetic Inductance Detectors (MKIDs) are cryogenic photon detectors and are attractive because they permit simultaneous time, energy and spatial resolution of faint astronomical sources. We present a cost-effective alternative to…

We study the mechanism of instability in transition edge sensor (TES) bolometers used for ground based observations of the Cosmic Microwave Background (CMB) at 270GHz. The instability limits the range of useful operating resistances of the…

The discovery of superconductivity in Magnesium Diborate (MgB$_2$) has stimulated great interest in the search of new superconductors with similar lattice structures. Unlike cuprate or iron-based superconductors, MgB$_2$ is indisputably a…

Radiation sensors based on the heating effect of the absorbed radiation are typically relatively simple to operate and flexible in terms of the input frequency. Consequently, they are widely applied, for example, in gas detection, security,…

We investigate rf SQUIDs (Superconducting QUantum Interference Devices), coupled to a resonant input circuit, a readout tank circuit and a preamplifier, by numerically solving the corresponding Langevin equations and optimizing model…

Increased power density in modern microelectronics has led to thermal management challenges which can cause degradation in performance and reliability. In many high-power electronic devices, the power consumption and heat removal are…