Related papers: Do Ambient Backscatter Communication Receivers Req…
To achieve the low noise and wide bandwidth required for millimeter wavelength astronomy applications, superconductor-insulator-superconductor (SIS) mixer based receiver systems have typically been used. This paper investigates the…
To combat the detrimental effects of the variability in wireless channels, we consider cross-layer rate adaptation based on limited feedback. In particular, based on limited feedback in the form of link-layer acknowledgements (ACK) and…
Integrated sensing and communication (ISAC) systems potentially encounter significant performance degradation in densely obstructed urban and non-line-of-sight scenarios, thus limiting their effectiveness in practical deployments. To deal…
In high-performance RF transceivers the thrust of has been on lower noise LNAs and high-power high-speed PAs. The performance trade-off has forced many solutions to have the LNA and PA on a separate die compared to the rest of baseband.…
This article analyzes the design of a low-noise amplifier intended as the input front-end for the measurement of the low-frequency components (below 10 Hz) of a 50 Ohm source. Low residual flicker is the main desired performance. This…
We propose receivers for bistatic sensing and communication that exploit a tensor modeling of the received signals. We consider a hybrid scenario where the sensing link knows the transmitted data to estimate the target parameters while the…
This paper studies the performance of backscatter communications (BC) over emerging fluid antenna (FA) technology. In particular, a single-antenna source sends information to a FA reader through the wireless forward (i.e., source-to-tag)…
Results of a study of the possibilities to reduce the low amplitude "tail" of the response characteristic of various electron detectors are presented. The main reason of such attribute of all detectors used in electron epectrometry is the…
To enhance the robustness and resilience of wireless communication and meet performance requirements, various environment-reflecting metrics, such as the signal-to-noise ratio (SNR), are utilized as the system parameter. To obtain these…
Identification of the type of communication technology and/or modulation scheme based on detected radio signal are challenging problems encountered in a variety of applications including spectrum allocation and radio interference…
Recently, communications systems that are both energy efficient and reliable are under investigation. In this paper, we concentrate on an energy-detection-based transmission scheme where a communication scenario between a transmitter with…
There is a growing interest in signaling schemes that operate in the wideband regime due to the crowded frequency spectrum. However, a downside of the wideband regime is that obtaining channel state information is costly, and the capacity…
Affine frequency division multiplexing (AFDM), an emerging multi-carrier modulation scheme, has garnered significant attention due to its resilience to Doppler shifts and capability to achieve full diversity in doubly dispersive channels.…
Visible Light Communication (VLC) is based on the dual use of the illumination infrastructure for wireless data communication. The major interest on this communication technology lies on its specific features to be a secure, cost-effective…
Wireless power transfer (WPT) using energy beamforming is a promising solution for low power Internet of Things (IoT) devices. In this work, we consider WPT from an energy transmitter (ET) employing retrodirective WPT using a large phased…
Ambient backscatter communication has shown great potential in the development of future wireless networks. It enables a backscatter transmitter (BTx) to send information directly to an adjacent receiver by modulating over ambient radio…
The advent of optical frequency standards with ultimate uncertainties in the low 1x10$^{-18}$ requires femtosecond frequency combs to support a similar level of resolution in the spectral transfer and the computation of optical frequency…
Upcoming modern communications are based on 5G specifications and aim at providing solutions for novel vertical industries. One of the major changes of the physical layer is the use of Low-Density Parity-Check (LDPC) code for channel…
Environmental noises and reverberation have a detrimental effect on the performance of automatic speech recognition (ASR) systems. Multi-condition training of neural network-based acoustic models is used to deal with this problem, but it…
This work considers a system where a dual-function radar transmitter (source) performs direct communication with a reader while simultaneously enabling ambient backscatter communication from a tag. The source embeds its message into a coded…