Related papers: Demonstration of a 1.2 Gbps Always-on Fully-Connec…

Emerging wireless applications such as 5G cellular, large intelligent surfaces (LIS), and holographic massive MIMO require antenna array processing at mm-wave frequencies with large numbers of independent digital transceivers. This paper…

The fast-rising demand for wireless bandwidth requires rapid evolution of high-performance baseband processing infrastructure. Programmable many-core processors for software-defined radio (SDR) have emerged as high-performance baseband…

The millimeter wave (mmW) frequency spectrum has been explored recently for large bandwidth communication. At these frequencies, narrow directional beams are required for communication since the signal attenuation is high due to atmospheric…

RF system-on-chip (RFSoC) devices provide the potential for implementing a complete radio astronomy receiver on a single board, but performance of the integrated analogue-to-digital converters is critical. We have evaluated the performance…

Integrated sensing and communication (ISAC) is a key enabler for future radio networks. This paper presents a sub-band full-duplex (SBFD) ISAC system that assigns non-overlapping OFDM subbands to sensing and communication, enabling…

Fixed-complexity Sphere Decoder (FSD) is a recently proposed technique for Multiple-Input Multiple-Output (MIMO) detection. It has several outstanding features such as constant throughput and large potential parallelism, which makes it…

We introduce an open-source architecture for next-generation Radio-Access Network baseband processing: 1024 latency-tolerant 32-bit RISC-V cores share 4 MiB of L1 memory via an ultra-low latency interconnect (7-11 cycles), a modular Direct…

High data rates are one of the most prevalent requirements in current mobile communications. To cover this and other high standards regarding performance, increasing coverage, capacity, and reliability, numerous works have proposed the…

We demonstrate a real-time implementation of multi-target detection and tracking using 5G New Radio (NR) physical downlink shared channel (PDSCH) waveform with 400 MHz bandwidth at 28 GHz carrier frequency. The hardware platform is built on…

Large-scale deployment of connected vehicles with cooperative sensing and maneuvering technologies increases the demand for vehicle-to-everything communication (V2X) band in 5.9 GHz. Besides the V2X spectrum, the under-utilized…

The upcoming 3GPP global mobile communication standard 6G strives to push the technological limits of radio frequency (RF) communication even further than its predecessors: Sum data rates beyond 100 Gbit/s, RF bandwidths above 1 GHz per…

This paper presents a 2 x 2 millimeter wave (mm-wave) multiple-input-multiple-output (MIMO) testbed that operates at around 30 GHz. The link assessment of the system operating at 26.25 GHz was carried out on a test bench, with a short…

To improve the poor performance of distributed operation and non-scalability of centralized operation in traditional cell-free massive MIMO, we propose a cell-free distributed collaborative (CFDC) massive multiple-input multiple-output…

This paper studies the performance of multi-hop and mesh networks composed of millimeter wave (MMW)-based radio frequency (RF) and free-space optical (FSO) links. The results are obtained in cases with and without hybrid automatic repeat…

In this study, we propose a general-purpose synchronization method that allows a set of software-defined radios (SDRs) to transmit or receive any in-phase/quadrature data with precise timings while maintaining the baseband processing in the…

In this study, we propose a low-cost and portable millimeter-wave software-defined radio (SDR) for wireless experimentation in the 60 GHz band. The proposed SDR uses Xilinx RFSoC2x2 and Sivers EVK06002 homodyne transceiver and provides a…

Software defined radio is a widely accepted paradigm for design of reconfigurable modems. The continuing march of Moore's law makes real-time signal processing on general purpose processors feasible for a large set of waveforms. Data rates…

Analog Multiple-Input Multiple-Output Radio-over-Copper (A-MIMO-RoC) is an effective all-analog FrontHaul (FH) architecture that exploits any pre-existing Local Area Network (LAN) cabling infrastructure of buildings to distribute…

The Xilinx ZCU111 Radio Frequency System on Chip (RFSoC) is a promising solution for reading out large arrays of microwave kinetic inductance detectors (MKIDs). The board boasts eight on-chip 12-bit / 4.096 GSPS analogue-to-digital…

Spurred by the dramatic mobile IP growth and the emerging Internet of Things (IoT) and cloud-based applications, wireless networking is witnessing a paradigm shift. By fully exploiting the spatial degrees of freedom, the massive…