Related papers: Exposure-Aware Beamforming for mmWave Systems: Fro…
User electromagnetic (EM) exposure is continuously being exacerbated by the evolution of multi-antenna portable devices. To mitigate the effects of EM radiation, portable devices must satisfy tight regulations on user exposure level,…
We present a dynamic resource allocation strategy for energy-efficient and Electromagnetic Field (EMF) exposure aware computation offloading at the wireless network edge. The goal is to maximize the overall system sum-rate of offloaded…
Without any radiation control measures, a large-scale mmWave antenna array at close range may lead to a large amount of electromagnetic exposure of human. In this paper, with the aid of pose detection in computer vision, a beamforming…
Energy beamforming (EB) is a key technique for achieving efficient radio-frequency (RF) transmission enabled wireless energy transfer (WET). By optimally designing the waveforms from multiple energy transmitters (ETs) over the wireless…
We investigate multi-objective adaptive beamformer design strategies for non-invasive microwave hyperthermia. Our focus is to address the challenges of maintaining focused power deposition in desired locations while reducing unwanted…
Massive Multiple-Input Multiple-Output systems with beamforming are key components of the 5th and the future 6th generation of networks. However, in some cases, where the BS serves the same user for a long period, and in some propagation…
In this paper, we propose a new beamforming design to maximize energy efficiency (EE) for multiple input single output interfering broadcast channels (IFBC). Under this model, the EE problem is non-convex in general due to the coupled…
This paper studies fast adaptive beamforming optimization for the signal-to-interference-plus-noise ratio balancing problem in a multiuser multiple-input single-output downlink system. Existing deep learning based approaches to predict…
Millimeter wave (mmWave) communication, utilizing beamforming techniques to address the inherent path loss limitation, is considered as one of the key technologies to support ever increasing high throughput and low latency demands of…
Beam training and prediction in millimeter-wave communications are highly challenging due to fast time-varying channels and sensitivity to blockages and mobility. In this context, infrastructure-mounted cameras can capture rich…
This paper studies the fast adaptive beamforming for the multiuser multiple-input single-output downlink. Existing deep learning-based approaches assume that training and testing channels follow the same distribution which causes task…
Energy beamforming (EB) is a key technique for achieving efficient radio-frequency (RF) transmission enabled wireless energy transfer (WET). By optimally designing the waveforms from multiple energy transmitters (ETs) over the wireless…
In this paper we study energy efficient joint power allocation and beamforming for coordinated multicell multiuser downlink systems. The considered optimization problem is in a non-convex fractional form and hard to tackle. We propose to…
The design of a set of beamformers for the multiuser multiple-input single-output (MISO) downlink that provides the receivers with prespecified levels of quality-of-service (QoS) can be quite challenging when the channel state information…
This paper presents an experimental study on mmWave beam profiling on a mmWave testbed, and develops a machine learning model for beamforming based on the experiment data. The datasets we have obtained from the beam profiling and the…
This study considers a point-to-point wireless link, in which both the transmitter and receiver are equipped with multiple antennas. In addition, two reconfigurable metasurfaces are deployed, one in the immediate vicinity of the transmit…
Accurate downlink channel information is crucial to the beamforming design, but it is difficult to obtain in practice. This paper investigates a deep learning-based optimization approach of the downlink beamforming to maximize the system…
3D beamforming is a promising approach for interference coordination in cellular networks which brings significant improvements in comparison with conventional 2D beamforming techniques. This paper investigates the problem of joint…
In this paper, we propose a multi-input multi-output beamforming transmit optimization model for joint radar sensing and multi-user communications, where the design of the beamformers is formulated as an optimization problem whose objective…
This letter studies a radio-frequency (RF) multi-user wireless power transfer (WPT) system, where an energy transmitter (ET) with a large number of antennas delivers energy wirelessly to multiple distributed energy receivers (ERs). We…