Related papers: Microwave Linear Analog Computer (MiLAC)-aided Mul…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…
In this paper, we study the channel estimation problem in correlated massive multiple-input-multiple-output (MIMO) systems with a reduced number of radio-frequency (RF) chains. Importantly, other than the knowledge of channel correlation…
Data rate requirements for cellular communications are expected to increase 1000-fold by 2020, compared to 2010. This is mainly because of the rapid increase in the number of wireless devices and data hungry applications per-device. This…
In this paper, we propose an analog beamsteering approach for enabling flexible hybrid beamforming design that can achieve performance close to singular value decomposition (SVD) based digital beamforming with single user case. As a…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
This paper presents a scalable beamforming design for maximizing the spectral efficiency (SE) of multi-reconfigurable intelligent surface (RIS)-aided communications through joint optimization of the precoder and RIS phase shifts in…
Low-resolution analog-to-digital converters (ADCs) have emerged as an efficient solution for massive multiple-input multiple-output (MIMO) systems to reap high data rates with reasonable power consumption and hardware complexity. In this…
In this paper, linear beamforming design for amplify-and-forward relaying cellular networks is considered, in which base station, relay station and mobile terminals are all equipped with multiple antennas. The design is based on minimum…
We investigate hybrid beamforming design for covert millimeter wave multiple-input multiple-output systems with finite-resolution digital-to-analog converters (DACs), which impose practical hardware constraints not yet considered by the…
Hybrid beamforming is considered a key enabler to realize millimeter wave (mmWave) multiple-input multiple-output (MIMO) communications due to its capability of considerably reducing the number of costly and power-hungry radio frequency…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
Low Earth Orbit (LEO) satellite networks are capable of improving the global Internet service coverage. In this context, we propose a hybrid beamforming design for holographic metasurface based terrestrial users in multi-altitude LEO…
This paper considers a reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) downlink communication system where hybrid analog-digital beamforming is employed at the base station (BS). We formulate a power minimization…
Low-resolution analog-to-digital converters (ADCs) have emerged as a promising technology for reducing power consumption and complexity in massive multiple-input multiple-output (MIMO) systems while maintaining satisfactory spectral and…
Deploying massive number of antennas at the base station side can boost the cellular system performance dramatically. Meanwhile, it however involves significant additional radio-frequency (RF) front-end complexity, hardware cost and power…
Intelligent metasurface has recently emerged as a promising technology that enables the customization of wireless environments by harnessing large numbers of low-cost reconfigurable scattering elements. However, prior studies have…
Digital beamforming and waveform generation techniques in MIMO radar offer enormous advantages in terms of flexibility and performance compared to conventional radar systems based on analog implementations. To allow for such fully digital…
In this letter, we consider optimal hybrid beamforming design to minimize the transmission power under individual signal-to-interference-plus-noise ratio (SINR) constraints in a multiuser massive multiple-input-multiple-output (MIMO)…
Integrated sensing and communication (ISAC) has been envisioned to play a more important role in future wireless networks. However, the design of ISAC networks is challenging, especially when there are multiple communication and sensing…
The main challenges in designing downlink coordinated multicast beamforming in massive multiple-input multiple output (MIMO) cellular networks are the complex computational solutions and significant fronthaul overhead for centralized…