Related papers: Antenna Coding Optimization for Pixel Antenna Empo…
In most multiple-input multiple-output (MIMO) communication systems, antennas are spaced at least half a wavelength apart to reduce mutual coupling. In this configuration, the maximum array gain is equal to the number of antennas. However,…
For a multiple-input multiple-output (MIMO) system with unknown channel state information (CSI), a novel low-density parity check (LDPC)-coded transmission (LCT) scheme with joint pilot and data channel estimation is proposed. To fine-tune…
Deploying massive number of antennas at the base station side can boost the cellular system performance dramatically. Meanwhile, it however involves significant additional radio-frequency (RF) front-end complexity, hardware cost and power…
Mobile-edge computing (MEC) and wireless power transfer (WPT) have been recognized as promising techniques in the Internet of Things (IoT) era to provide massive low-power wireless devices with enhanced computation capability and…
This paper focuses on a particular transmission scheme called local network coding, which has been reported to provide significant performance gains in practical wireless networks. The performance of this scheme strongly depends on the…
Integrating mobile edge computing (MEC) and wireless power transfer (WPT) has been regarded as a promising technique to improve computation capabilities for self-sustainable Internet of Things (IoT) devices. This paper investigates a…
In this paper, we study the sum rate maximization for successive zero-forcing dirty-paper coding (SZFDPC) with per-antenna power constraint (PAPC). Although SZFDPC is a low-complexity alternative to the optimal dirty paper coding (DPC),…
Simultaneous wireless information and power transfer (SWIPT) is a promising solution to increase the lifetime of wireless nodes and hence alleviate the energy bottleneck of energy constrained wireless networks. As an alternative to…
Wireless power transfer (WPT) technologies hold promise for enhancing device autonomy, particularly for energy-limited IoT systems. This paper presents experimental results on coherent and non-coherent transmit diversity approaches for WPT,…
Radio frequency wireless power transfer (WPT) enables charging low-power mobile devices without relying on wired infrastructure. Current existing WPT systems are typically designed assuming far-field propagation, where the radiated energy…
We propose network coding as an energy efficient data transmission technique in core networks with non-bypass and bypass routing approaches. The improvement in energy efficiency is achieved through reduction in the traffic flows passing…
The explosive demand for data has called for solution approaches that range from spectrally agile cognitive radios with novel spectrum sharing, to use of higher frequency spectrum as well as smaller and denser cell deployments with diverse…
In this paper, we study the average throughput performance of energy beamforming in a multi-antenna wireless-powered communication network (WPCN). The considered network consists of one hybrid access-point (AP) with multiple antennas and a…
This paper presents a physical layer network coding (PNC) approach for network MIMO (N-MIMO) systems to release the heavy burden of backhaul load. The proposed PNC approach is applied for uplink scenario in binary systems, and the design…
To meet the future demand for huge traffic volume of wireless data service, the research on the fifth generation (5G) mobile communication systems has been undertaken in recent years. It is expected that the spectral and energy efficiencies…
The use of low-resolution digital-to-analog and analog-to-digital converters (DACs and ADCs) significantly benefits energy efficiency (EE) at the cost of high quantization noise in implementing massive multiple-input multiple-output (MIMO)…
This paper studies a wireless-energy-transfer (WET) enabled massive multiple-input-multiple-output (MIMO) system (MM) consisting of a hybrid data-and-energy access point (H-AP) and multiple single-antenna users. In the WET-MM system, the…
Massive multiple-input multiple-output (mMIMO) antenna systems and inter-band carrier aggregation (CA)-enabled multi-band communication are two key technologies to achieve very high data rates in beyond fifth generation (B5G) wireless…
WiMAX technology is based on the IEEE 802.16 specification of which IEEE 802.16-2004 and 802.16e amendment are Physical (PHY) layer specifications. IEEE 802.16-2004 currently supports several multiple-antenna options including Space-Time…
Large antenna arrays can steer narrow beams towards a target area, and thus improve the communications capacity of wireless channels and the fidelity of radio sensing. Hardware that is capable of continuously-variable phase shifts is…