Related papers: High-Efficiency Octave Bandwidth Rectifier for Ele…
A rectenna (rectifying antenna) is usually applied to a microwave power transmission (MPT) system as a terminal, which receives microwave (MW) power and converts them into DC power. A 5.8 GHz aperture-coupled patch antenna array is…
This paper introduces a highly efficient rectenna (rectifying antenna) using a binary optimization algorithm. A novel pixelated receiving antenna has been developed to match the diode impedance of a rectifier, eliminating the need for a…
A microwave rectifier at 5.8 GHz without any capacitors is presented, which owns a measured MW-to-DC conversion efficiency of 68.1%. A harmonic rejection filter and a DC pass filter, which replace lumped capacitors in conventional microwave…
This paper presents an efficient dual-band rectifier for radiofrequency energy harvesting (RFEH) applications at FM and GSM bands. The single-port rectifier circuit, which comprises a 3-port network, optimized T-matching circuits and…
This paper presents the design and analysis of a superdirective rectenna optimized for enhanced RF-to-DC efficiency and realised gain, featuring direct impedance matching between the antenna and the rectifier. Employing passively loaded,…
This letter presents a novel adaptive power division strategy, which uses two rectifying diodes with nonlinear impedance characteristics that are configured in parallel to function optimally at their individual power levels. Through the…
In this letter, we present an innovative design for a compact, high-efficiency all-polarization receiving rectenna tailored for wireless power transmission. This rectenna, which integrates an antenna with two same rectifier units, employs…
This letter proposes a high-efficiency dual-band class-F rectifier for wireless power transmission (WPT). The rectifier comprises a dual-band harmonic termination network, a dual-band matching network, a single Schottky diode, and a dc pass…
Voltage doubler rectifiers are usually applied to systems with high voltage and low current requirement. An X band voltage doubler rectifier has been developed with 72% conversion efficiency. To the best of our knowledge, the obtained…
In ambient electromagnetic energy harvesting systems, the input power to the rectifier is low. To improve rectification efficiency, Schottky diodes, which are sensitive to low power, are commonly selected as rectifying devices to convert…
This paper present high precision halfwave rectifier circuit in dual phase output mode by 0.5 micrometer CMOS technology, plus or minus 1.5 V low voltage, it has received input signal and sent output current signal, respond in high…
This letter describes a 40.68 MHz wireless power transfer receiver for implantable applications focused on minimizing tissue heating. The system features a novel power radiated efficiency optimization strategy and a fast-settling active…
Harmonic generation during radio frequency (RF)-dc conversion causes performance degradation of a microwave rectifying circuit. To suppress and recycle the harmonic power, this letter proposes a novel compact dual-band resonator (DBR) based…
High-power interferers are one of the main hurdles in wideband communication channels. To that end, this paper presents a wideband interferer detection method. The presented technique operates by sampling the incoming signal as an input,…
A highly efficient and compact quad band energy harvester (QBEH) circuit based on the extended composite right and left handed transmission lines (ECRLHTLs) technique is presented.The design procedure based on ECRLHTLs at four desired…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…
At millimeter wave (mmWave) frequencies, the higher cost and power consumption of hardware components in multiple-input multiple output (MIMO) systems do not allow beamforming entirely at the baseband with a separate radio frequency (RF)…
A delta-function method was proposed to quantitatively evaluate the electromagnetic impedance matching degree. Measured electromagnetic parameters of {\alpha}-Fe/Fe3B/Y2O3 nanocomposites are applied to calculate the matching degree by the…
We numerically demonstrate a new type of waveform-selective metasurface that senses the difference in incoming waveforms or pulse widths at the same frequency. Importantly, the proposed structure contains precise rectifier circuits that,…
In this work, we propose a technique to enhance the performance of circular patch antennas using an embedded system of cylindrical impedance surfaces. The technique utilizes a derived analytical model of a circular patch antenna containing…