Related papers: FPGA-Enabled Modulo ADC with x100 Dynamic-Range Ex…

The fundamental limits of communication over multiple-input multiple-output (MIMO) networks are considered when a limited number of one-bit analog to digital converters (ADC) are used at the receiver terminals. Prior works have mainly…

The combination of orthogonal frequency modulation (OFDM) and multiple-input multiple-output (MIMO) systems plays an important role in modern communication systems. In order to meet the growing throughput demands, future MIMO-OFDM receivers…

Dynamic comparators are the core of high-speed, high-resolution analog-to-digital converters (ADCs) used for communication applications. Most of the dynamic comparators attain high-speed operation only for sufficiently high input difference…

Computer-generated holography (CGH) has gained wide attention with deep learning-based algorithms. However, due to its nonlinear and ill-posed nature, challenges remain in achieving accurate and stable reconstruction. Specifically, ($i$)…

The Unlimited Sensing Framework (USF) is a digital acquisition protocol that allows for sampling and reconstruction of high dynamic range signals. By acquiring modulo samples, the USF circumvents the clipping or saturation problem that is a…

The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although…

Data center interconnects (DCIs) will have to support throughputs of 400 Gbps or more per wavelength in the near future. To achieve such high data rates, coherent modulation and detection is used, which conventionally requires high-speed…

Network-assisted full-duplex (NAFD) distributed massive multiple input multiple output (M-MIMO) enables the in-band full-duplex with existing half-duplex devices at the network level, which exceptionally improves spectral efficiency. This…

In this paper, we present a basic model for time-interleaved photonic analog-to-digital converter (TIPADC) and analyze its linear, nonlinear, and noise performance. The basic operation mechanism of TIPADC is illustrated and the linear…

We describe a modular multi-channel data acquisition system based on the 5-15 Gigasample-per-second waveform-recording PSEC4 chip. The system architecture incorporates two levels of hardware with FPGA-embedded system control and in-line…

In this paper we will present the first results of applying a digital processing technology in low-level gamma spectroscopy with HPGE detectors. An experimental gamma spectrometer using Flash ADC module is built and tested. The test system…

The design and measurement results of ultra-low power, fast 10-bit Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) prototypes in 65 nm CMOS technology are presented. Eight prototype ADCs were designed using two…

Timing systems based on Analog-to-Digital Converters are widely used in the design of previous high energy physics detectors. In this paper, we propose a new method based on deep learning to extract the time information from a finite set of…

We study collaborative machine learning systems where a massive dataset is distributed across independent workers which compute their local gradient estimates based on their own datasets. Workers send their estimates through a multipath…

Conventional analog and mixed-signal (AMS) circuit designs heavily rely on manual effort, which is time-consuming and labor-intensive. This paper presents a fully automated design methodology for Successive Approximation Register (SAR)…

Digital control has become increasingly widespread in modern power electronic converters. When acquiring feedback signals such as the inductor current, synchronizing the analog-to-digital converter (ADC) with the digital pulse-width…

In task-based quantization, a multivariate analog signal is transformed into a digital signal using a limited number of low-resolution analog-to-digital converters (ADCs). This process aims to minimize a fidelity criterion, which is…

Communication systems use the concept of transmitting information using the electrical distribution network as a communication channel. To enable the transmission data signal modulated on a carrier signal is superimposed on the electrical…

The analog signals generated in the read-out electronics of radiation detectors are shaped prior to the digitization in order to improve the signal to noise ratio (SNR). The real amplitude of the analog signal is then obtained using digital…

Massive multiple input multiple output (MIMO) antenna arrays eventuate a huge amount of circuit costs and computational complexity. To satisfy the needs of high precision and low cost in future green wireless communication, the conventional…