Related papers: Low-Complexity Rydberg Array Reuse: Modeling and R…
Milimeter wave (mmWave) band mobile communications can be a solution to the continuously increasing traffic demand in modern wireless systems. Even though mmWave bands are scarcely occupied, the design of a prospect transceiver should…
Joint estimation of carrier frequency and direction of arrival (DOA) for multiple signals has been found in many practical applications such as Cognitive Radio (CR). However, Nyquist sampling mechanism is costly or implemented due to wide…
To enable user diversity and multiplexing gains, a fully digital precoding multiple input multiple output (MIMO) architecture is typically applied. However, a large number of radio frequency (RF) chains make the system unrealistic to…
The use of higher frequencies and MIMO is important in many 5G use cases. However, the available channel models for millimeter waves (mmWaves) currently demand investigation and the number of measurements is still limited. Using simulators…
This work studies a low-complexity design for reconfigurable intelligent surface (RIS)-aided multiuser multiple-input multiple-output systems. The base station (BS) applies receive antenna selection to connect a subset of its antennas to…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…
Hybrid multiple-antenna transceivers, which combine large-dimensional analog pre/postprocessing with lower-dimensional digital processing, are the most promising approach for reducing the hardware cost and training overhead in massive MIMO…
The integration of pattern-reconfigurable antennas into hybrid multiple-input multiple-output (MIMO) architectures presents a promising path toward high-efficiency and low-cost transceiver solutions. Pattern-reconfigurable antennas can…
A practical and scalable multicast beamformer design in multi-input multi-output~(MIMO) coded caching~(CC) systems is introduced in this paper. The proposed approach allows multicast transmission to multiple groups with partially…
In this paper, we develop a communication-oriented complex baseband equivalent model for superheterodyne Rydberg atomic quantum receivers (RAQRs). The model explicitly captures photodetection-induced signal-dependent shot noise and its…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
Rydberg atom arrays have emerged as a leading platform for quantum information science. Reaching system sizes of hundreds of long-lived qubits, these arrays are used for highly coherent analog quantum simulation, as well as digital quantum…
The problem of multi-objective design of sparse MIMO arrays for better multitarget detection capabilities is considered. A novel approach for efficient utilization of the antenna design resources; namely, the number of available array…
The demands for high data rates in 6G networks have driven the transition toward higher frequencies and larger antenna apertures, giving rise to the near-field communications. In the near-field region, spherical waves enable beam focusing…
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems is a favorable candidate for the fifth generation (5G) cellular systems. However, a key challenge is the high power consumption imposed by its numerous…
Measurement-based quantum computing relies on the rapid creation of large-scale entanglement in a register of stable qubits. Atomic arrays are well suited to store quantum information, and entanglement can be created using highly-excited…
Recently, Rydberg atom has emerged as an attractive choice to realize quantum sensing of low-frequency electric field. The progress so far has mostly utilized the intensity and phase changes in probe laser and the corresponding detection…
Digital beamforming and waveform generation techniques in MIMO radar offer enormous advantages in terms of flexibility and performance compared to conventional radar systems based on analog implementations. To allow for such fully digital…
To satisfy the capacity requirements of future mobile systems, under-utilized millimeter wave frequencies can be efficiently exploited by employing massive MIMO technology with highly directive beamforming. Hybrid analog-digital beamforming…
Millimeter-wave (mm-wave) communication is a key technology for future wireless networks. To combat significant path loss and exploit the abundant mm-wave spectrum, effective beamforming is crucial. Nevertheless, conventional fully digital…