Related papers: Environment-Aware MIMO Channel Estimation in Pilot…
Accurately mapping the radio environment (e.g., identifying wireless signal strength at specific frequency bands and geographic locations) is crucial for efficient spectrum sharing, enabling Secondary Users~(SUs) to access underutilized…
Channel state information (CSI) is crucial for massive multi-input multi-output (MIMO) system. As the antenna scale increases, acquiring CSI results in significantly higher system overhead. In this letter, we propose a novel channel…
Radio frequency (RF) map is a promising technique for capturing the characteristics of multipath signal propagation, offering critical support for channel modeling, coverage analysis, and beamforming in wireless communication networks. This…
We address the problem of noise and interference corrupted channel estimation in massive MIMO systems. Interference, which originates from pilot reuse (or contamination), can in principle be discriminated on the basis of the distributions…
Estimation in few-bit MIMO systems is challenging, since the received signals are nonlinearly distorted by the low-resolution ADCs. In this paper, we propose a deep learning framework for channel estimation, data detection, and pilot signal…
In large scale dynamic wireless networks, the amount of overhead caused by channel estimation (CE) is becoming one of the main performance bottlenecks. This is due to the large number users whose channels should be estimated, the user…
This paper proposes a deep learning-based channel estimation method for multi-cell interference-limited massive MIMO systems, in which base stations equipped with a large number of antennas serve multiple single-antenna users. The proposed…
Massive multiple-input multiple-output (MIMO) is a critical technology for future fifth-generation (5G) systems. Reduced pilot contamination (PC) enhanced system performance, and reduced inter-cell interference and improved channel…
Accurate channel state information (CSI) underpins reliable and efficient wireless communication. However, acquiring CSI via pilot estimation incurs substantial overhead, especially in massive multiple-input multiple-output (MIMO) systems…
Massive MIMO uses a large number of antennas to increase the spectral efficiency (SE) through spatial multiplexing of users, which requires accurate channel state information. It is often assumed that regular pilots (RP), where a fraction…
Reconfigurable intelligent surface is a potential technology component of future wireless networks due to its capability of shaping the wireless environment. The promising MIMO systems in terms of extended coverage and enhanced capacity…
Multiple-input multiple-output (MIMO) millimeter wave (mmWave) communication is a key technology for next generation wireless networks. One of the consequences of utilizing a large number of antennas with an increased bandwidth is that…
In pursuit of enhanced quality of service and higher transmission rates, communication within the mid-band spectrum, such as bands in the 6-15 GHz range, combined with extra large-scale multiple-input multiple-output (XL-MIMO), is…
Large scale multiple-input multiple-output (MIMO) system is considered one of promising technologies for realizing next-generation wireless communication system (5G) to increasing the degrees of freedom in space and enhancing the link…
This paper addresses the problem of estimating sparse channels in massive MIMO-OFDM systems. Most wireless channels are sparse in nature with large delay spread. In addition, these channels as observed by multiple antennas in a neighborhood…
This paper investigates the robust wideband channel estimation problem in the millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems. In such a scenario, the beam squint effect that the array response vectors vary…
Unmanned aerial vehicles (UAVs) operating in dynamic wind fields must generate safe and energy-efficient trajectories under physical and environmental constraints. Traditional planners, such as A* and kinodynamic RRT*, often yield…
Multiple-input multiple-output (MIMO) systems are well suited for millimeter-wave (mmWave) wireless communications where large antenna arrays can be integrated in small form factors due to tiny wavelengths, thereby providing high array…
Extremely large-scale multiple-input multiple-output (XL-MIMO) is a promising technique to enable versatile applications for future wireless communications.To realize the huge potential performance gain, accurate channel state information…
The problem of excessive pilot overhead required for uplink massive MIMO channel estimation is well known, let alone when it is considered along with wideband (OFDM) transmissions. Towards channel estimators that are both efficient and…