Related papers: Non-Linear Precoding via Dirty Paper Coding for Ne…
Physical layer network coding (PNC) has been studied to serve wireless network MIMO systems with much lower backhaul load than approaches such as Cloud Radio Access Network (Cloud-RAN) and coordinated multipoint (CoMP). In this paper, we…
Coded caching (CC) can substantially enhance network performance by leveraging memory as an additional communication resource. However, the use of CC is challenging in various practical applications due to dynamic user behavior. The…
We consider two-way amplify and forward relaying, where multiple full-duplex user pairs exchange information via a shared full-duplex massive multiple-input multiple-output (MIMO) relay. We derive closed-form lower bound for the spectral…
Direct satellite uplink is severely constrained by limited link budgets, which hinder the exploitation of wideband resources, and ultimately limit the throughout. This paper presents a pilot-less coded modulation scheme based on sparse…
The power consumption of digital-to-analog converters (DACs) constitutes a significant proportion of the total power consumption in a massive multiuser multiple-input multiple-output (MU-MIMO) base station (BS). Using 1-bit DACs can…
The problem of communication over binary dirty paper (DP) using nested polar codes is considered. An improved scheme, focusing on low delay, short to moderate blocklength communication is proposed. Successive cancellation list (SCL)…
In future 6G communication systems, large-scale antenna arrays promise enhanced signal strength and spatial resolution, but they also increase the complexity of beam training. Moreover, as antenna counts grow and carrier wavelengths shrink,…
One of the challenges often faced with wireless communication systems is its limited range and data-rate. Distributed Transmit Beamforming (DTB) techniques are being developed to address these two issues to provide reliable connectivity…
In this paper, we propose a novel joint caching and massive multiple-input multiple-output (MIMO) transmission scheme, referred to as \emph{cache-aided massive MIMO}, for multi-cell downlink transmission to multiple cache-enabled receivers.…
In this paper, a Full Duplex (FD) eXtremely Large (XL) Multiple-Input Multiple-Output (MIMO) node equipped with reconfigurable metasurface antennas at its transmission and reception sides is considered, which is optimized for simultaneous…
We propose a method for channel training and precoding in FDD massive MIMO based on deep neural networks (DNNs), exploiting Downlink (DL) channel covariance knowledge. The DNN is optimized to maximize the DL multi-user sum-rate, by…
In this study, a scheduling policy of layered decoding for quasi-cycle (QC) low-density parity-check (LDPC) codes with high throughput and good performance is designed. The influence of scheduling on the delay of the decoder's hardware…
In this letter, we consider linear precoding for downlink massive multi-user (MU) multiple-input multiple-output (MIMO) systems. We propose the novel successively-regularized zero forcing (SRZF) precoding, which exploits successive null…
Cell-free (CF) multiple-input multiple-output (MIMO) systems generally employ linear precoding techniques to mitigate the effects of multiuser interference. However, the power loss, efficiency, and precoding accuracy of linear precoders are…
Massive multi-user (MU) multiple-input multiple- output (MIMO) is widely believed to be a core technology for the upcoming fifth-generation (5G) wireless communication standards. The use of low-precision digital-to-analog converters (DACs)…
Integer-forcing (IF) precoding, also known as downlink IF, is a promising new approach for communication over multiple-input multiple-output (MIMO) broadcast channels. Inspired by the integer-forcing linear receiver for multiple-access…
Extremely large antenna arrays (ELAAs) operating in high-frequency bands have spurred the development of near-field communication, driving advancements in beam training design. This paper introduces an efficient near-field beam training…
LDPC (Low Density Parity Check) codes are among the most powerful and widely adopted modern error correcting codes. The iterative decoding algorithms required for these codes involve high computational complexity and high processing…
As a subfield of network coding, physical-layer network coding (PNC) can effectively enhance the throughput of wireless networks by mapping superimposed signals at receiver to other forms of user messages. Over the past twenty years, PNC…
Cell-free massive multiple-input multiple-output (MIMO) is a key technology for next-generation wireless systems. The integration of cell-free massive MIMO within the open radio access network (O-RAN) architecture addresses the growing need…