Related papers: Low and high frequency noise in LEDs
Heterodyne interferometry for precision science often comes with an optical phase modulation, for example, for intersatellite clock noise transfer for gravitational wave (GW) detectors in space, exemplified by the Laser Interferometer Space…
We study the noise properties and efficiency of a mesoscopic resonant-level conductor which is used as a quantum detector, in the regime where transport through the level is only partially phase coherent. We contrast models in which…
We analyze the dissipative dynamics of a two-level quantum system subject to low-frequency, e.g. 1/f noise, motivated by recent experiments with superconducting quantum circuits. We show that the effect of transverse linear coupling of the…
We propose a model for 1/f flux noise in superconducting devices (f is frequency). The noise is generated by the magnetic moments of electrons in defect states which they occupy for a wide distribution of times before escaping. A trapped…
We demonstrate that the measurement of $1/f^{\alpha}$ noise at the single molecule or nano-object limit is remarkably distinct from the macroscopic measurement over a large sample. The single particle measurements yield a conditional…
High-harmonic generation in solids has emerged as a powerful probe of ultrafast electron dynamics and lattice motion, and recent theoretical work has suggested that thermally driven lattice fluctuations can act as an effective source of…
The quantum indeterminacy caused by non-commutativity of observables at different times sets a lower bound on the voltage noise power spectrum in any conducting material. This bound is calculated explicitly in the case of semiconductors…
We show that 1/f noise is produced in a 3D electron glass by charge fluctuations due to electrons hopping between isolated sites and a percolating network at low temperatures. The low frequency noise spectrum goes as \omega^{-\alpha} with…
We report that low frequency (up to 200 kHz) noise spectra of magnetic tunnel junctions with areas ~10^{-10}cm^2$ at 10 Kelvin deviate significantly from the typical 1/f behavior found in large area junctions at room temperature. In most…
As a consequence of a general trend in the physics of oscillators and clocks towards optics, phase and frequency metrology is rapidly moving to optics too. Yet, optics is not replacing the traditional radio-frequency (RF) and microwave…
A high-sensitivity LED based photoacoustic NO$_2$ sensor is demonstrated. Sensitive photoacoustic gas sensors based on incoherent light sources are typically limited by background noise and drifts due to a strong signal generated by light…
Mechanical resonators are widely used as precision clocks and sensitive detectors that rely on the stability of their eigenfrequencies. The phase noise is determined by different factors ranging from thermal noise and frequency noise of the…
A time-dependent bias voltage on a tunnel junction generates a time-dependent modulation of its current fluctuations, and in particular of its variance. This translates into an excitation at frequency $\tilde{f}$ generating correlations…
We report results of experimental investigation of the low-frequency noise in the top-gate graphene transistors. The back-gate graphene devices were modified via addition of the top gate separated by 20 nm of HfO2 from the single-layer…
We have measured the low-frequency resistance fluctuations (1 mHz<f<10 Hz) in Ag nanowires of diameter 15 nm<d<200 nm at room temperatures. The power spectral density (PSD) of the fluctuations has a 1/f^{\alpha} character as seen in…
We present measurements of the low-frequency noise of microstrip-coupled, lumped-element aluminum kinetic inductance detectors that use hydrogenated amorphous silicon parallel-plate capacitors (Al/a-Si:H MS-PPC-LEKIDs), which are under…
The power spectrum of quantum dot fluorescence exhibits $1/f^\beta$ noise, related to the intermittency of these nanosystems. As in other systems exhibiting $1/f$ noise, this power spectrum is not integrable at low frequencies, which…
Reasonable vibration reduction design is an important way to achieve low phase noise index of airborne frequency source output signal. Aiming at the problem of phase noise deterioration of an airborne frequency source under random…
The distinction between chiral, trivial helical, and topological helical edge modes can be effectively made using quantum noise measurements at finite temperatures. Quantum noise measurements consist of mainly two components. The first is…
We investigate the capability of dynamical decoupling techniques to reduce decoherence from a realistic environment generating 1/f noise. The predominance of low frequency modes in the noise profile allows for decoherence scenarios where…