Related papers: MMGaP: Multi-User MIMO Detection and Precoding usi…
In this paper we present an optimized parallel implementation of a flexible MAP decoder for synchronization error correcting codes, supporting a very wide range of code sizes and channel conditions. On mid-range GPUs we demonstrate decoding…
The UFMC modulation is among the most considered solutions for the realization of beyond-OFDM air interfaces for future wireless networks. This paper focuses on the design and analysis of an UFMC transceiver equipped with multiple antennas…
Multiple-input multiple-output (MIMO) system is the key technology for long term evolution (LTE) and 5G. The information detection problem at the receiver side is in general difficult due to the imbalance of decoding complexity and decoding…
Distributed MIMO (D-MIMO) has emerged as a key architecture for future sixth-generation (6G) networks, enabling cooperative transmission across spatially distributed access points (APs). However, most existing studies rely on idealized…
High throughput satellites employing multibeam antennas and full frequency reuse for broadband satellite services are considered in this paper. Such architectures offer, for example, a cost-effective solution to optimize data delivery and…
Millimeter wave (mmWave) massive MIMO can achieve orders of magnitude increase in spectral and energy efficiency, and it usually exploits the hybrid analog and digital precoding to overcome the serious signal attenuation induced by mmWave…
The paper presents a deep learning-aided iterative detection algorithm for massive overloaded MIMO systems. Since the proposed algorithm is based on the projected gradient descent method with trainable parameters, it is named as trainable…
This paper tackles the problem of millimeter-Wave (mmWave) channel estimation in massive MIMO communication systems. A new Bayes-optimal channel estimator is derived using recent advances in the approximate belief propagation (BP) Bayesian…
Massive MIMO is a compelling wireless access concept that relies on the use of an excess number of base-station antennas, relative to the number of active terminals. This technology is a main component of 5G New Radio (NR) and addresses all…
Millimeter-wave (mmWave) networks, integral to 5G communication, offer a vast spectrum that addresses the issue of spectrum scarcity and enhances peak rate and capacity. However, their dense deployment, necessary to counteract propagation…
Multimodal pre-training breaks down the modality barriers and allows the individual modalities to be mutually augmented with information, resulting in significant advances in representation learning. However, graph modality, as a very…
This paper investigates the network-assisted full-duplex (NAFD) cell-free millimeter-wave (mmWave) networks, where the distribution of the transmitting access points (T-APs) and receiving access points (R-APs) across distinct geographical…
We investigate the uplink throughput achievable by a multiple-user (MU) massive multiple-input multiple-output (MIMO) system in which the base station is equipped with a large number of low-resolution analog-to-digital converters (ADCs).…
Cell-free massive multiple-input multiple-output (MIMO) is a promising network to offer huge improvement of the achievable rate compared with conventional cellular massive MIMO systems. However, the commonly adopted Shannon-type achievable…
The deployment of large-scale antenna arrays for cellular base stations (BSs), termed as `Massive MIMO', has been a key enabler for meeting the ever-increasing capacity requirement for 5G communication systems and beyond. Despite their…
Upcoming physical layer (PHY) processing solutions, leveraging multiple-input multiple-output (MIMO) advances, are expected to support broad transmission bandwidths and the concurrent transmission of multiple information streams. However,…
In this paper, we consider the amplify-and-forward relay networks in mmWave systems and propose a hybrid precoder/combiner design approach. The phase-only RF precoding/combining matrices are first designed to support multi-stream…
We propose a machine learning (ML) and smartphone-assisted framework for uplink performance prediction in a private, realistic 5G cellular system using real-time measurements in both indoor and outdoor settings. This work presents a…
Millimeter wave (mmWave) cellular systems will enable gigabit-per-second data rates thanks to the large bandwidth available at mmWave frequencies. To realize sufficient link margin, mmWave systems will employ directional beamforming with…
Cell-free (CF) massive multiple-input multiple-output (M-MIMO) technology plays a prominent role in the beyond fifth-generation (5G) networks. However, designing a high performance CF M-MIMO detector is a challenging task due to the…