Related papers: Influence of carbon dioxide and water concentratio…
In this study we synthesized thin films of titanium oxide doped with thulium and/or ytterbium to modify the incident spectrum on the solar cells. This could be achieved either by photoluminescence up-converting devices, or down-converting…
Entropy stabilization has garnered significant attention as a new approach to designing novel materials. Much of the work in this area has focused on bulk ceramic processing, leaving entropy-stabilized thin films relatively underexplored.…
Ruthenium dioxide (RuO$_2$) thin films were synthesized by Chemical Solution Deposition (CSD) on silicon substrates using only water and acetic acid as solvents. The microstructure, phase-purity, electrical and optical properties as well as…
Micron-thick boron films have been deposited by Pulsed Laser Deposition in vacuum on several substrates at room temperature. The use of high energy pulses (>700 mJ) results in the deposition of smooth coatings with low oxygen uptake even at…
We report the atomic layer deposition of titanium dioxide on carbon nanosheet templates and investigate the effects of post-deposition annealing in a helium environment using different characterization techniques. The crystallization of the…
The effect of water exposure on MgB2 is studied by submerging an 800 nm thick MgB2 film into deionized water at room temperature for 1 hour, 4 hours, 10 hours, and 15 hours, and by analyzing the resulting material using scanning electron…
Thin aluminum oxide films were deposited by a new and simple physicochemical method called chemical liquid phase deposition (CLD) on semiconductor materials. Aluminum sulfate with crystallized water and sodium bicarbonate were used as…
Significative enhance in magnetocaloric effect due to finite size and surface effects is reported in Terbium(Tb) thin films in the helimagnetic phase (corresponding to a temperature range from $T_C$=219 K to $T_N$=231 K), for external…
Boron carbide thin films were synthesised by laser-assisted chemical vapour deposition (LCVD), using a CO2 laser beam and boron trichloride and methane as precursors. Boron and carbon contents were measured by electron probe microanalysis…
The effects of wet chemical processing conventionally employed in device fabrication standards are systematically studied on molybdenum oxide (MoOx) ultra-thin films. We have combined x-ray photoelectron spectroscopy (XPS), angle resolved…
Carbon is one of the most investigated materials and shows chaotic behavior in terms of evolving structure. Synthesizing carbon materials largely depend on the deposition technique, process parameters, condition of substrate surface and…
The structure, composition and electrophysical characteristics of low-temperature silicon dioxide films under influence of various technology factors, such as ion implantation, laser irradiation, thermal and photonic annealing, have been…
Thin films made of deformable micro- and nano-units, such as biological membranes, polymer interfaces, and particle-laden liquid surfaces, exhibit a complex behavior during drying, with consequences for various applications like wound…
Intentionally deposited thin films exposed to atmosphere often develop unintentionally deposited few monolayer films of surface contamination. This contamination arises from the diverse population of volatile organics and inorganics in the…
The nucleation mechanisms during solution deposition of organic semiconductor thin films determine the grain morphology and may influence the crystalline packing in some cases. Here, in-situ optical spectromicroscopy in reflection mode is…
This paper presents the effect of different cooling rate after annealing on structural and electrical properties of TiO2 thin films. Titanium dioxide thin film was deposited on a silicon substrate using DC magnetron technique. After…
Thin TiO2 films on quartz substrates were prepared by spin coating of undoped and metal-ion-doped Sol Gel precursors. These films were characterised by Scanning Electron Microscopy, Laser Raman Microspectroscopy, Xray Diffraction and UV Vis…
The present work is essentially focused on the study of optical and structural properties of hydrogenated amorphous silicon thin films (a-Si:H) prepared by radio-frequency cathodic sputtering. We examine separately the influence of hydrogen…
Boron carbide thin films of different thicknesses deposited by ion beam sputtering were studied. The deposited films were characterized by grazing incidence hard x-ray reflectivity (GIXR), resonant soft x-ray reflectivity (RSXR), x-ray…
Thin block copolymer films have attracted considerable academic attention because of their ability to self-assemble into various microstructures, many of which have potential technological applications. Despite the ongoing interest, little…