Related papers: Booster Cavity Damper Redesign for PIP-II
The paper proposes a new technique that substantially improves blind digital modulation identification (DMI) algorithms that are based on higher-order statistics (HOS). The proposed technique takes advantage of noise power estimation to…
A conventional resonant detector is often subject to a trade-off between bandwidth and peak sensitivity that can be traced back to quantum Cramer-Rao Bound. Anomalous dispersion has been shown to improve it by signal amplification and is…
We demonstrate the suppression of parametric instability using through optical actuation in an electro-optical feedback loop, stabilising the high order optical mode content in an 80 metre long Fabry-Perot cavity. The loop suppression of…
Interferometric gravitational wave detectors operate with high optical power in their arms in order to achieve high shot-noise limited strain sensitivity. A significant limitation to increasing the optical power is the phenomenon of…
Laser intensity noise limits performance in quantum sensing, metrology, and computing. Existing stabilization methods face a trade-off between bandwidth and complexity: electronic feedback loops are speed-limited, while optical resonators…
The maximum achievable beam current in an Energy Recovery Linac (ERL) is often constrained by Beam Breakup (BBU) instability. Our previous research highlighted that filling patterns have a substantial impact on BBU instabilities in…
The extraction bucket position in the Fermilab Booster is controlled with a cogging process that involves the comparison of the Booster RF count and the Recycler Ring revolution marker. A one RF bucket jitter in the extraction bucket…
We study mechanical amplification and noise squeezing in a nonlinear nanomechanical resonator driven by an intense pump near its dynamical bifurcation point, namely, the onset of Duffing bistability. Phase sensitive amplification is…
PIP-II is an 800 MEV superconducting linac that is in the initial acceleration chain for the Fermilab accelerator complex. The RF system consists of a warm front-end with an ion source, RFQ and buncher cavities along with 25 superconducting…
Active discussion on the high energy physics priorities in the US carried out since summer of 2013 resulted in changes in Fermilab plans for future development of the existing accelerator complex. In particular, the scope of Project X was…
We examine the potential impacts to slip-stacking from a change of the Booster cycle-rate from 15- to 20-Hz. We find that changing the Booster cycle-rate to 20-Hz would greatly increase the slip-stacking bucket area, while potentially…
The CLIC damping rings will produce ultra-low emittance beam, with high bunch charge, necessary for the luminosity performance of the collider. To limit the beam emittance blow-up due to oscillations, the pulse power modulators for the…
Dual mode orthogonal frequency division multiplexing with index modulation (DM-OFDM-IM) is recently proposed, which modulates all subcarriers to eliminate the limits of spectrum efficiency in OFDM with index modulation (OFDM-IM). In…
Cavity optomechanical phenomena, such as cooling, amplification or optomechanically induced transparency, emerge due to a strong imbalance in the dissipation rates of the parametrically coupled electromagnetic and mechanical resonators.…
The hybrid Stimulated Raman Scattering - Two Plasmon Decay instability had shown to play the dominant role for plasma waves excitation and energy absorption at interaction of very intense femtosecond obliquely incident $p$-polarized laser…
An introduction and the status of R&D activities for a high-resolution, "cold" beam position monitor (BPM) and the related read-out electronics are discussed. Two different BPM detector concepts, to be attached to the SC quadrupole and…
Off-axis beams passing through an accelerating cavity excite dipole modes among other higher order modes (HOMs). These modes have linear dependence on the transverse beam offset from the cavity axis. Therefore they can be used to monitor…
Orthogonal frequency division multiplexing with index modulation (OFDM-IM) is a novel multicarrier scheme, which uses the indices of the active subcarriers to transmit data. OFDM-IM also inherits the high peak-to-average power ratio (PAPR)…
The mitigation of nonlinear distortion caused by power amplifiers (PA) in Orthogonal Frequency Division Multiplexing (OFDM) systems is an essential issue to enable energy efficient operation. In this work we proposed a new algorithm for…
Hybrid analog and digital (HAD) beamforming has been recently receiving considerable deserved attention for a practical implementation on the large-scale antenna systems. As compared to full digital beamforming, partial-connected HAD…