Related papers: 2.4-GHz Integrated CMOS Low-Noise Amplifier (Engli…

A Low-Power Variable Gain (VG) mm-Wave Low Noise Amplifier (LNA) is designed and simulated in a 28-nm CMOS process. The LNA utilizes a simple, yet novel, technique presented in this paper to vary the small-signal output resistance to…

Noise level frequently set the basic limit on the smallest signal. New noise reduction technology and amplifiers voltage-noise density, yet still offer high speed, high accuracy, and low power solution. Low noise amplifiers always play a…

This paper presents a low-noise amplifier (LNA) that was developed for a new radio telescope comprised of 512 parabolic dish antennas. The LNA closely interfaces to a custom-made antenna feed with an impedance co-designed to provide noise…

A low-noise amplifier (LNA) amplifies a very low-power signal without significantly degrading its signal-to-noise ratio. This paper provides the design of a linear low noise amplifier with the transistor BFP 640 using bilateral approach…

This paper demonstrates designing and developing of an Ultra-Low Noise Amplifier which should potentially increase the sensitivity of the existing Magnetic Resonance Imaging (MRI) systems. The Design of the LNA is fabricated and…

To achieve the low noise and wide bandwidth required for millimeter wavelength astronomy applications, superconductor-insulator-superconductor (SIS) mixer based receiver systems have typically been used. This paper investigates the…

As the Internet of Things (IOT) is growing rapidly, there is an emerging need to facilitate development of IOT devices in the design cycle while optimized performance is obtained in the field of operation. This paper develops…

This study undertakes the theoretical design, CAD modeling, realization, and performance analysis of a microwave low-noise amplifier (LNA) which has been accurately developed for operation at 3.0 GHz (S-band). The objective of this research…

This paper investigates the impact of technological constraints on passive elements in the design of inductively degenerated CMOS low-noise amplifiers (LNAs). A theoretical analysis is combined with circuit simulations in a 130-nm CMOS…

One of the major challenges in communication, radar, and electronic warfare receivers arises from nearby device interference. The paper presents a 2-6 GHz GaN LNA front-end with onboard sensing, processing, and feedback utilizing…

A low power cascode SiGe BiCMOS low noise amplifier (LNA) with current reuse and zero-pole cancellation is presented for ultra-wideband (UWB) application. The LNA is composed of cascode input stage and common emitter (CE) output stage with…

The paper describes the project, implementation and test of a C-band (5GHz) Low Noise Amplifier (LNA) using new low noise Pseudomorphic High Electron Mobility Transistors (pHEMTS) from Avago. The amplifier was developed to be used as a cost…

Next-generation (5G/6G) wireless systems demand low-power mm-wave phased-array ICs. Variable-gain LNAs (VGLNAs) are key building blocks enabling hardware complexity reduction, performance enhancement and functionality extension. This paper…

A new cryogenic noise calibration source for radio astronomy receivers is presented. Dissipated power is only 4.2 mW, allowing it to be integrated with the cold part of the receiver. Measured long-term stability, sensitivity to bias…

Next-generation cellular systems require low-power mm-wave phased-array ICs. Variable-gain LNAs (VG-LNAs) are key blocks enabling reduced hardware complexity, performance improvement and added functionalities. This paper reports a low-power…

This paper presents a low power, low cost transceiver architecture to implement radar-on-a-chip. The transceiver comprises of a full ultra-wideband (UWB) transmitter and a full UWB band receiver. A design methodology to maximize the tuning…

In high-performance RF transceivers the thrust of has been on lower noise LNAs and high-power high-speed PAs. The performance trade-off has forced many solutions to have the LNA and PA on a separate die compared to the rest of baseband.…

Large-scale superconducting quantum computers require massive numbers of high-performance cryogenic low-noise amplifiers (cryo-LNA) for qubit readout. Here we present a C-Band monolithic microwave integrated circuit (MMIC) cryo-LNA for this…

This paper presents a compact low-power, low-noise bioamplifier for multi-channel electrode arrays, aimed at recording action potentials. The design we put forth attains a notable decrease in both size and power consumption. This is…

This article introduces a design of a Low Noise Amplifier (LNA), for the field of diamond particle detectors. This amplifier is described from simulation to measurements, which include pulses from {\alpha} particles detection. In hadron…