Related papers: Moderator Simulation for the Compact Positron Sour…
We describe and characterize a simple, low cost, low phase noise microwave source that operates near 6.800 GHz for agile, coherent manipulation of ensembles of 87Rb. Low phase noise is achieved by directly multiplying a low phase noise 100…
A many-mode laser with nonlinear modal interaction could serve as a model system to study many-body physics. However, precise and continuous tuning of the interaction strength over a wide range is challenging. Here, we present a unique…
Microcavity solitons enable miniaturized coherent frequency comb sources. However, the formation of microcavity solitons can be disrupted by stimulated Raman scattering (SRS), particularly in the emerging crystalline microcomb materials…
This letter describes a 40.68 MHz wireless power transfer receiver for implantable applications focused on minimizing tissue heating. The system features a novel power radiated efficiency optimization strategy and a fast-settling active…
A diamond-like carbon circular target is proposed to improve the $\gamma$-ray emission and pair production with lasers intensity of $8\times 10^{22} ~\mathrm{W/cm^2}$ by using two-dimensional particle-in-cell simulations with quantum…
A soliton microcomb can play a crucial role in narrow-grid optical communications by replacing many independently operated lasers in wavelength-division multiplexing systems. In this work, we designed and demonstrated power-efficient…
We proposed a new approach, which is inspired by the method of super-resolution (SR) structured illumination microscopy (SIM) for overcoming the resolution limit in microscopy due to diffraction of light, for increasing the resolution of…
Optical solitons have long been of interest both from a fundamental perspective and because of their application potential. Both cubic (Kerr) and quadratic nonlinearities can lead to soliton formation, but quadratic solitons can practically…
A compact and fast electromagnetic calorimeter prototype was designed, built, and tested in preparation for a next-generation, high-rate muon g-2 experiment. It uses a simple assembly procedure: alternating layers of 0.5-mm-thick tungsten…
We propose a method for soliton formation in whispering-gallery-mode (WGM) resonators through input phase modulation. Our numerical simulations of a variant of the Lugiato-Lefever equation suggest that modulating the input phase at a…
Understanding the dynamics of positron cooling in gases, including the fraction of positrons surviving to thermalisation, is critical for accurate interpretation of positron lifetime spectra, for the development of efficient positron…
A technique for measuring high-energy electrons using Si detectors of various thicknesses that are much smaller than the range of the examined electrons is presented. The advantages of the method are discussed on the basis of…
In 2008 the Cornell Electron/Positron Storage Ring (CESR) was reconfigured from an electron/positron collider to serve as a testbed for the International Linear Collider (ILC) damping rings. One of the primary goals of the CESR Test…
The next generation of e+/e- colliders will require a very intense flux of gamma rays to allow high current polarized positrons to be produced. This can be achieved by converting polarized high energy photons in polarized pairs into a…
The new method for producing of the polarized relativistic positrons is suggested. A beam of unpolarized positrons accelerated up to a few GeV can be polarized during a head-on collision with an intense circularly polarized lazer wave.…
SPARC_LAB is a facility designed for the production of FEL radiation and the exploration of advanced acceleration techniques using a high brightness electron photo-injector. Specifically, particle-driven plasma wakefield acceleration (PWFA)…
The next generation of very-short-baseline reactor experiments will require compact detectors operating at surface level and close to a nuclear reactor. This paper presents a new detector concept based on a composite solid scintillator…
The Booster Neutrino Experiment (MiniBooNE) searches for numu-to-nue oscillations using the O(1 GeV) neutrino beam produced by the Booster synchrotron at the Fermi National Accelerator Laboratory (FNAL). The Booster delivers protons with 8…
This paper proposes a novel method to enhance the performance of the modulator for fifth-generation wireless communication (5G) by exploiting modulation instability (MI). We show that MI can reduce the bias voltage of the modulator…
High gradient accelerator injectors have been widely studied throughout the world-leading accelerator facilities. The demand for high frequency cavities have led the Detector, Accelerator and instrumentation laboratory (KAHVELab) in…