Related papers: Improved SINR Approximation for Downlink SDMA-base…

In this paper we study on a massive MIMO relay system with linear precoding under the conditions of imperfect channel state information at the transmitter (CSIT) and per-user channel transmit correlation. In our system the source-relay…

We present and analyze a new robust feedback and transmit strategy for multiuser MIMO downlink communication systems, termed Rate Approximation (RA). RA combines the flexibility and robustness needed for reliable communications with the…

The signal-to-interference-plus-noise ratio (SINR) is central to performance optimization in user-centric beamforming for satellite-based non-terrestrial networks (NTNs). Its assessment either requires the transmission of dedicated pilots…

We develop a general downlink model for multi-antenna heterogeneous cellular networks (HetNets), where base stations (BSs) across tiers may differ in terms of transmit power, target signal-to-interference-ratio (SIR), deployment density,…

In this paper, we consider spatial-division multiple-access (SDMA) systems with one base station with multiple antennae and a number of single antenna mobiles under noisy limited CSIT feedback. We propose a robust noisy limited feedback…

Various system tasks like interference coordination, handover decisions, admission control etc. in upcoming cellular networks require precise mid-term (spanning over a few seconds) performance models. Due to channel-dependent scheduling at…

To fully utilize the spatial multiplexing gains or array gains of massive MIMO, the channel state information must be obtained at the transmitter side (CSIT). However, conventional CSIT estimation approaches are not suitable for FDD massive…

We focus on the realistic maximization of the uplink minimum signal-to-interference-plus-noise ratio (SINR) of a general multiple-input single-output (MISO) system assisted by an intelligent reflecting surface (IRS) in the large system…

Designing an efficient scheme in physical layer enables cognitive radio (CR) users to efficiently utilize resources dedicated to primary users (PUs). In this paper in order to maximize the SU's throughput, the SU's transceivers beamforming…

Channel state information (CSI) is very crucial for any wireless communication systems. Typically, CSI can be characterized at the receiver side using channel impulse response (CIR). Many observations have shown that the CIR of broadband…

Given the critical dependence of broadcast channels by the accuracy of channel state information at the transmitter (CSIT), we develop a general downlink model with zero-forcing (ZF) precoding, applied in realistic heterogeneous cellular…

This paper investigates the sum spectral efficiency maximization problem in downlink multiuser multiple-input multiple-output (MIMO) systems with low-resolution quantizers at an access point (AP) and users. In particular, we consider…

In this paper, we consider the design of a multiple-input multiple-output (MIMO) transmitter which simultaneously functions as a MIMO radar and a base station for downlink multiuser communications. In addition to a power constraint, we…

Multiple-input-multiple-output (MIMO) systems of current LTE releases are capable of adaptation in the azimuth only. Recently, the trend is to enhance system performance by exploiting the channel's degrees of freedom in the elevation, which…

This paper presents a large-system analysis of the performance of joint channel estimation, multiuser detection, and per-user decoding (CE-MUDD) for randomly-spread multiple-input multiple-output (MIMO) direct-sequence code-division…

Accurate channel impulse response (CIR) is required for coherent detection and it can also help improve communication quality of service in next-generation wireless communication systems. One of the advanced systems is multi-input…

We investigate the uplink throughput achievable by a multiple-user (MU) massive multiple-input multiple-output (MIMO) system in which the base station is equipped with a large number of low-resolution analog-to-digital converters (ADCs).…

Massive spatial modulation aided multiple-input multiple-output (SM-MIMO) systems have recently been proposed as a novel combination of spatial modulation (SM) and of conventional massive MIMO, where the base station (BS) is equipped with a…

The rapid development of IoT technology has led to a shortage of spectrum resources and energy, giving rise to simultaneous wireless information and power transfer (SWIPT) technology. However, traditional multiple input multiple output…

Massive multiple-input multiple-output (MIMO) and full-duplex (FD) are promising candidates for achieving the spectral efficiency to meet the needs of 5G communications. One essential key to realizing practical FD massive MIMO systems is…