Related papers: Analysis of Broad Beam Beamforming for Collocated …

This paper considers the beamforming design for a multiuser multiple-input single-output (MISO) downlink with an arbitrary number of (context-specific) shaping constraints. In this setup, the state-of-the-art beamforming schemes cannot…

Developing resource allocation algorithms with strong real-time and high efficiency has been an imperative topic in wireless networks. Conventional optimization-based iterative resource allocation algorithms often suffer from slow…

The requirement of high data-rate in the fifth generation wireless systems (5G) calls for the ultimate utilization of the wide bandwidth in the mmWave frequency band. Researchers seeking to compensate for mmWave's high path loss and to…

In this paper, a new user-scheduling-and-beamforming method is proposed for multi-user massive multiple-input multiple-output (massive MIMO) broadcast channels in the context of two-stage beamforming. The key ideas of the proposed…

A simple method is proposed for use in a scenario involving a single-antenna source node communicating with a destination node that is equipped with two antennas via multiple single-antenna relay nodes, where each relay is subject to an…

Since hybrid beamforming (HBF) can approach the performance of fully-digital beamforming (FDBF) with much lower hardware complexity, we investigate the HBF design for beam-hopping (BH) low earth orbit (LEO) satellite communications…

Multi-Cell (MC) systems are present in mobile network operations from the first generation to the fifth generation of wireless networks, and considers the signals of all users to a base station (BS) centered in a cell. Cell-Free (CF)…

We present a novel, power- & hardware-efficient, multiuser, multibeam RIS (Reflective Intelligent Surface) architecture for multiuser MIMO, especially for very high frequency bands (e.g., high mmWave and sub-THz), where channels are…

Network-assisted full-duplex (NAFD) distributed massive multiple input multiple output (M-MIMO) enables the in-band full-duplex with existing half-duplex devices at the network level, which exceptionally improves spectral efficiency. This…

This paper proposes optimal beam patterns of analog beamforming for SU (Single User) massive MIMO (Multi-Input Multi-Output) transmission systems. For hybrid beamforming in SU massive MIMO systems, there are several design parameters such…

A new approach to distributed cooperative beamforming in relay networks with frequency selective fading is proposed. It is assumed that all the relay nodes are equipped with finite impulse response (FIR) filters and use a filter-and-forward…

Massive multiple-input multiple-output (MIMO) systems have been drawing considerable interest due to the growing throughput demands on wireless networks. In the uplink, massive MIMO systems are commonly studied assuming that each base…

Millimeter Wave (mmWave) communications with full-duplex (FD) have the potential of increasing the spectral efficiency, relative to those with half-duplex. However, the residual self-interference (SI) from FD and high pathloss inherent to…

We investigate the beam squint effect in uniform planar arrays (UPAs) and propose an efficient hybrid beamforming (HBF) design to mitigate the beam squint in multiple-input multiple-output orthogonal frequency-division multiplexing…

Beam split is a critical challenge in wideband THz massive MIMO systems, arising from frequency-dependent beam misalignment that degrades communication performance, particularly in scenarios with narrow beamwidths and large arrays. This…

Despite its promising performance gain, the realization of mmWave massive MIMO still faces several practical challenges. In particular, implementing massive MIMO in the digital domain requires hundreds of RF chains matching the number of…

This letter develops a novel transmit beamforming (BF) design for canceling self-interference (SI) in analog in-band full-duplex phased arrays. Our design maximizes transmit BF gain in a desired direction while simultaneously reducing SI…

The potentials of massive multiple-input multiple-output (MIMO) are all based on the available instantaneous channel state information (CSI) at the base station (BS). Therefore, the user in frequency-division duplexing (FDD) systems has to…

The amalgamation of cell-free networks and reconfigurable intelligent surface (RIS) has become a prospective technique for future sixth-generation wireless communication systems. In this paper, we focus on the precoding and beamforming…

As the dense deployment of access points (APs) in cell-free massive multiple-input multiple-output (CF-mMIMO) systems presents significant challenges, per-AP coverage can be expanded using large-scale antenna arrays (LAAs). However, this…