Related papers: Rapid-cycling ReBCO dipole magnet concept for muon…
A possible application of the HTS (ReBCO) rapid-cycling dipole magnet [1] in the first stages of muon acceleration consisting of Recirculating Linear Accelerator (RLA) and followed-up first Rapid Cycling Synchrotron (RCS-1) is presented.…
Development of energy-efficient fast cycling accelerator magnets is critical for the next generation of proton rapid cycling synchrotrons (RCS) for neutrino research and booster accelerators of future muon colliders. We see a unique…
Conceptual designs of a superconducting dipole magnet for a Storage Ring of a Muon Collider with a 1.5 TeV center of mass (c.o.m.) energy and an average luminosity of 10 34 cm-2s-1 are presented. In contrast to proton machines, the dipoles…
Two 2200m radius hybrid rings of fixed superconducting magnets and iron magnets ramping at 200 Hz and 330 Hz are used to accelerate muons. Muons are given 25 GeV of RF energy per orbit. Acceleration is from 250 GeV/c to 2400 GeV/c and…
Muon acceleration from 30 to 750 GeV in 72 orbits using two rings in the 1000m radius Tevatron tunnel is explored. The first ring ramps at 400 Hz and accelerates muons from 30 to 400 GeV in 28 orbits using 14 GV of 1.3 GHz superconducting…
Conceptual designs of superconducting magnets for the storage ring of a Muon Collider with a 1.5 TeV c.o.m. energy and an average luminosity of 10 34 cm-2s-1 are presented. All magnets are based on Nb3Sn superconductor and designed to…
Design, fabrication and assembly of a novel fast-cycling accelerator magnet is presented. A short-sample magnet is powered with a single-turn HTS cable capable to carry 80 kA current at 20 K and generate 1.75 T field in a 40 mm magnet gap.…
High-field superconducting magnets with a dipole field of 16 T and above enable future energy-frontier circular particle colliders. Although we believe these magnets can be built, none exists today. They can also be a showstopper for future…
We report results of the experimental test of the High Temperature Superconductor based fast cycling prototype accelerator magnet capable to operate up to about 300 Tesla per second field ramping rate with some 0.5 T field in the magnet…
Four decades ago development of high-current superconducting NbTi wire cables revolutionized the magnet technology for energy frontier accelerators, such as Tevatron, RHIC and LHC. The NbTi based magnets offered advantage of much higher…
We discuss possible acceleration scenarios and methods for a mu+ mu- collider. The accelerator must take the beams from ~100 MeV to 2 TeV within the muon lifetime (2.2 x 10**(-6) E(mu)/m(mu) uS), while compressing bunches of 10**(12) muons…
Rare-Earth Barium Copper Oxide (REBCO) coated conductors are an attractive option for application in high field accelerator magnets due to their high critical field and the convenience of fabrication without heat treatment compared to some…
A 1.8 T dipole magnet using thin grain oriented silicon steel laminations has been constructed as a prototype for a muon synchrotron ramping at 400 Hz. Following the practice in large 3 phase transformers and our own Opera-2d simulations,…
The first acceleration stage for this muon collider scenario includes twenty passes through a single two GeV Linac. Teardrop shaped arcs of 1.8 Tesla fixed field magnets are used at each end of the Linac. This dogbone geometry minimizes…
REBCO tape has remarkable performance for super-conducting technology, but it is extremely expensive and it is a strongly anisotropic superconductor. The design of a 3.5 T collider dipole is presented in which all turns of the body winding…
A strategy is presented by which a tape-stack REBCO cable may be configured in a conformal winding in such a way that all tape faces are ~parallel to B thorughout the winding, yielding ~3x more current performance than is possible in…
The most effective way to achieve very high collision energies in a circular particle accelerator is to maximize the field strength of the main bending dipoles. In dipole magnets using Nb-Ti superconductor the practical field limit is…
Development of REBCO cables that carry high electrical current in high magnetic field is crucial for future large-scale magnet applications. This experimental work presents the critical current measurements of two different REBCO cables by…
The Muon Collider, proposed under the International Muon Collider Collaboration (IMCC), represents a groundbreaking advancement in circular collider technology. By using muons instead of protons or electrons, this collider has the potential…
A proton-driven Muon Collider, in the configuration that has resulted from the efforts of the International Muon Collider Collaboration (IMCC), poses multiple and exceptional magnet system challenges. Addressing these challenges will…