Related papers: Experimental and numerical study on current distri…
We investigate the pinning mechanism in high-critical-current polycrystalline samples of Bi-2223 (Bi2Sr2Ca2Cu3O10) utilized in high current applications. Using differential magneto-optical (DMO) imaging technique, we track the magnetic…
The REBCO coated conductor has the potential to be widely used in ultrahigh field magnets. It is well known, however, that it is not mechanically strong against delamination in the direction normal to its surface due to its intrinsic…
Advances on no-insulation REBCO coil technology has made understanding and controlling contact resistivity increasingly im-portant. Praffin (wax) impregnation is a process that has been used for improving mechanical stability of insulated…
The in-plane current profile within multilayers of generic structure Ta/Pt/(CoNi)/Pt/Ta is investigated. A large set of samples where the thickness of each layer is systematically varied was grown, followed by the measurement of the sheet…
Different magnet applications require compact high current cables. Among the proposed solutions, the Twisted Stacked Tape Cable (TSTC) is easy to manufacture and has very high tape length usage efficiency. In this kind of cables the tapes…
The level of current non-uniformity in NbTi CICCs sections near the joints in combination with the magnet field profile needs attention in view of proper joint design. The strand Joule power and current distribution at quench under DC…
For realization the new functional materials and devices by conductive nanomaterials, how to control and realize the optimum networks structures are import point for fundamental, applied and industrial science. In this manuscript, the…
The spin transfer switching current distribution within a cell was studied in magnetic tunnel junction based structures having alumina barriers with resistance-area product (RA) of 10 to 30 Ohm-um2 and tunneling magneto-resistance (TMR) of…
High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent…
Current distributions in thin film wires bent at different angles were investigated with a conformal mapping method. The technique of angles rounding using three parameters was suggested. This technique enabled to obtain a smooth line…
We consider a current-carrying, phase-coherent multi-probe conductor to which a small tunneling contact is attached. We treat the conductor and the tunneling contact as a phase-coherent entity and use a Green's function formulation of the…
Combining quasistatic and time-resolved transport measurements with X-ray and neutron diffraction experiments we study the non-equilibrium states that arise in pure and in Ti substituted Ca$_2$RuO$_4$ under the application of current…
The redistribution of electrical currents in resistor networks after single-bond failures is analyzed in terms of current-redistribution factors that are shown to depend only on the topology of the network and on the values of the bond…
An appealing direction to change the properties of strongly correlated materials is to induce nonequilibrium steady states by the application of a direct current. While access to these novel states is of high scientific interest, Joule…
We present an experimental study of the effects of driving current direction on ferromagnetic resonance in NiFe foils. The rf driving current was applied to NiFe foils of different shapes. In rectangular samples with a close-to-uniform flow…
In high power density superconducting motors, superconducting tapes are usually stacked and connected together at terminals to improve the current capacity. When a parallel sinusoidal magnetic field is applied on this partially coupled…
In a no-insulation (NI) REBCO magnet, the turn-to-turn contact resistivity (Rc) determines its quench self-protection capability, charging delay time and the energy loss during field ramps. Therefore it is critically important to be able to…
Transverse domain wall (TDW) dynamics in long and narrow spin valves with perpendicular current injection is theoretically investigated. We demonstrate that stable traveling-wave motion of TDWs with finite velocity survives for strong…
Numerical methods are developed to solve the problem of abnormal changes of current (conductivity) in polymer composite films which may be used as current, pressure or temperature sensors. General nonlinear model includes the heat equation,…
Circulating currents occurring in windings of electric machines received rising interest recent years. Circulating currents represent unwanted currents flowing between parallel-connected conductors. This phenomenon is due to various reasons…