Related papers: Scaling particle-size segregation in wide-ranging …
Transport and particulate processes are ubiquitous in environmental, industrial and biological applications, often involving complex geometries and porous media. In this work we present a general population balance model for particle…
A recently proposed schematic model for the non--linear rheology of dense colloidal dispersions is compared to flow curves measured in suspensions that consist of thermosensitive particles. The volume fraction of this purely repulsive model…
We present a detailed comparison of the rheological behaviour of sheared sediment beds in a pressure-driven, straight channel configuration based on data that was generated by means of fully coupled, grain-resolved direct numerical…
Using three-dimensional Discrete Element Method (DEM) simulations, we investigate the erosion dynamics of a cohesive bed composed of wet spherical particles subjected to the shear flow of an overlying non-cohesive granular layer. Cohesion…
We study particle-scale motion in sheared highly polydisperse amorphous materials, in which the largest particles are as much as ten times the size of the smallest. We find strikingly different behavior from the more commonly studied…
We carried out three-dimensional simulations, with about 1.4 million particles, of phase segregation in a low density binary fluid mixture, described mesoscopically by energy and momentum conserving Boltzmann-Vlasov equations. Using a…
We present an experimental study of segregation of granular matter in a quasi-two dimensional silo emptying out of an orifice. Size separation is observed when multi-sized particles are used with the larger particles found in the center of…
A multi-scale model is presented for predicting the magnitude and rate of powder blending in a rotating drum blender. The model combines particle diffusion coefficient correlations from the literature with advective flow field information…
Diverging correlation lengths on either side of the jamming transition are used to formulate a rheological model of granular shear flow, based on the propagation of stress through force chain networks. The model predicts three distinct flow…
Employing the discrete element method, we study the rheology of dense granular media mixtures, varying in size, density, and frictional properties of particles, across a spectrum from quasi-static to inertial regimes. By accounting for the…
A change of solute dispersion regime with the flow velocity has been studied both at the macroscopic and pore scales in a transparent array of capillary channels using an optical technique allowing for simultaneous local and global…
In spite of many attempts to model dense granular flow, there is still no general theory capable of describing different types of flows, such as gravity-driven drainage in silos and wall-driven shear flows in Couette cells. Here, we…
The Discrete Particle Method (DPM) is used to model granular flows down an inclined chute. We observe three major regimes: static piles, steady uniform flows and accelerating flows. For flows over a smooth base, other (quasi-steady) regimes…
Molecular dynamics simulations with varying damping are used to examine the effects of inertia and spatial dimension on sheared disordered solids in the athermal, quasistatic limit. In all cases the distribution of avalanche sizes follows a…
The problem of an accurate Eulerian-Lagrangian modeling of inertial particle dispersion in Large Eddy Simulation (LES) of turbulent wall-bounded flows is addressed. We run Direct Numerical Simulation (DNS) for turbulent channel flow at…
In this letter, we focus on the size effect of granular column collapses, which are potentially connected to the dynamics of complex geophysical flows, even if the link between microscopic structures of granular assemblies and their…
Increase in viscosity under increasing shear stress, known as shear thickening (ST), is one of the most striking properties of dense particulate suspensions. Under appropriate conditions, they exhibit discontinuous shear thickening (DST),…
We formulate multifractal models for velocity differences and gradients which describe the full range of length scales in turbulent flow, namely: laminar, dissipation, inertial, and stirring ranges. The models subsume existing models of…
We discover unified scaling laws for the mean wall shear stress and the mean velocity profile in turbulent boundary layers subject to favorable and adverse mean pressure gradients-including flows with separation and reattachment. We use the…
We use existing 3D Discrete Element simulations of simple shear flows of spheres to evaluate the radial distribution function at contact that enables kinetic theory to correctly predict the pressure and the shear stress, for different…