Related papers: Optimising Photothermal Silver Nanoparticles for E…
Atomic Force Microscopy (AFM) and Ultrasonic Force Microscopy (UFM) have been applied to the characterization of composite samples formed by SrTiO 3 (STO) nanoparticles (NPs) and polyvinyl alcohol (PVA). The morphological features of the…
The preparation of Ag 2+x Se thin films with thicknesses between 4 nm and 3000 nm by pulsed laser deposition on single crystalline NaCl and MgO substrates is reported. The films are perfectly dense and show a good lateral uniformity with a…
The present paper deals with the systematic growth of plasmonic gold nanoparticles (Au NPs) on molybdenum disulphide (MoS$_2$) nanosheets as well as the effect of Au NPs on the optical and magnetic properties. The crystalline nature of the…
Intrinsic hydrogenated amorphous silicon films can provide outstanding surface passivation of crystalline silicon wafer surfaces. This quality of Intrinsic hydrogenated amorphous silicon makes it valuable in heterojunction with intrinsic…
Plasmonic nanomaterials offer a direct and effective approach to harnessing solar energy. Specifically, plasmonic semiconductors enable a highly efficient light-to-heat conversion process, outperforming noble metals in stability,…
This article describes the optical properties of nanostructures composed of silver particles embedded into a gold matrix. In previous studies these materials were shown to exhibit temperature dependent transitions to a highly conductive and…
A single nanoparticle (NP) mass spectrometry method was used to measure sublimation rates as a function of nanoparticle temperature (TNP) for a number of individual graphite and graphene NPs. Initially, the NP sublimation rates were ca. 400…
Polymer assisted spherical FeNi nanoparticles were prepared via wet chemical method using hydrazine as a reducing agent and polymers (PVP and PEG) as reducing and stabilizing agent. Structural studies performed using XRD and TEM shows…
We present results of computational modeling of the formation of uniform spherical silver particles prepared by rapid mixing of ascorbic acid and silver-amine complex solutions in the absence of a dispersing agent. Using an accelerated…
We show that plasmonic solid-state nanopores with tunable hole diameter can be prepared via a photocatalytic effect resulting from the enhanced electromagnetic field inside a metallic ring prepared on top of a dielectric nanotube. Under…
Nanoparticles (NPs) are widely used in diverse application areas, such as medicine, engineering, and cosmetics. The size (or volume) of NPs is one of the most important parameters for their successful application. It is relatively…
We investigate novel strategies to extend the sensitivity of dark matter direct detection experiments to energy deposits well below the thresholds of conventional detectors. In liquid-argon time-projection chambers equipped with silicon…
Carbon-nanofillers are known for improving the desired properties of polymers. The dispersion quality of nanofillers in the matrix is vital for the fabrication of high-performance nanocomposites. An effective approach for improving…
Solar cells with the structure ITO-PEDOT:PSS-Ag:SnS-Al were fabricated with the active layer of tin sulphide with silver nano-particles (Ag:SnS) grown by thermal co-evaporation. To understand the influence of the silver nanoparticles on the…
Near surface silver nanoparticles embedded in silicon oxide were obtained by 40 keV silver negative ion implantation without the requirement of an annealing step. Ion beam induced local heating within the film leads to an exo-diffusion of…
Armchair graphene nanoribbons (AGNRs) with sub-nanometer width are potential materials for fabrication of novel nanodevices thanks to their moderate direct band gaps. AGNRs are usually synthesized by polymerizing precursor molecules on…
The optical and morphological properties of hollow gold nanoparticles (HGNPs) can be finely modified by employing Poly-L-Lysine hydrobromide (PLL), an homo poly aminoacid of the L-lysine, used as reducer and stabilizer. We investigate…
Magnetic nanoparticles (MNPs) form the foundation of many technologies, frequently serving to purify proteins or cells from a biological sample or to remove environmental contaminants. Their success relies on their magnetic response, which…
Molecules with versatile functionalities and well-defined structures, can serve as building blocks for extreme nanoscale devices. This requires their precise integration into functional heterojunctions, most commonly in the form of…
We report on the morphological effects induced by the inhomogeneous absorption of cylindrically polarized femtosecond laser irradiation of silver (Ag) in sub-ablation conditions. A theoretical prediction of the role of surface plasmon…