Related papers: High-power RF amplifier for ultracold atom experim…
This paper presents a Gm-C dynamic amplifier with high linearity and high temperature and power supply voltage stability. The main part of the amplifier employs two asymmetric differential pairs to enhance transconductance linearity. The…
Radio-frequency (RF) control is a key technique in cold atom experiments. We present a compact and efficient RF circuit based on a capacitive transformer network, where a low-frequency coil operating up to 30MHz serves as both an intrinsic…
Solid state amplifiers are being increasingly used instead of electronic vacuum tubes to feed accelerating cavities with radio frequency power in the 100 kW range. Power is obtained from the combination of hundreds of transistor amplifier…
We report on measurements of a Josephson amplifier (J-amp) suitable for quantum-state qubit readout in the microwave domain. It consists of two microstrip resonators which intersect at a Josephson ring modulator. A maximum gain of about 20…
This paper reviews the main types of radio-frequency power amplifiers which are, or may be, used for high-power hadron accelerators. It covers tetrodes, inductive output tubes, klystrons and magnetrons with power outputs greater than 10 kW…
Any amplifier requires coupling to its internal degrees of freedom for energy gain. This coupling introduces extra quantum noise to the output. On the other hand, if the internal degree of the amplifier can be accessed and manipulated, we…
Fault-tolerant spin-based quantum computers will require fast and accurate qubit readout. This can be achieved using radio-frequency reflectometry given sufficient sensitivity to the change in quantum capacitance associated with the qubit…
We design and implement a low-impedance, high-current radio-frequency (RF) circuit, enabling fast coherent coupling between magnetic levels in cold alkali atomic samples. It is based on a compact shape-optimized coil that maximizes the RF…
We provide a comprehensive comparison of linear amplifiers and microwave photon-counters in axion dark matter experiments. The study is done assuming a range of realistic operating conditions and detector parameters, over the frequency…
A voltage amplifier, based on the BFU500XRR NPN transistor in a common-emitter configuration, was developed for the readout of the fast output of an ONSEMI MicroFC-10035 Silicon Photomultiplier (SiPM). This amplifier was tested and…
A prototype ultrahigh resolution spectrograph has been built with an adaptive optics telescope. It provides $250,000$ resolving power, 300 \AA\ wavelength coverage and 0.8\% efficiency.
A quantum-limited amplifier enables the amplification of weak signals while introducing minimal noise dictated by the principles of quantum mechanics. These amplifiers serve a broad spectrum of applications in quantum computing, including…
We present an all-fiber design for a Tm-based fiber amplifier that can tune over 1992-2065 nm with 300-350 W single-frequency (<100 kHz) output. Over 180 W is achieved out to 2085 nm with <10% ASE content without utilizing ASE spectral…
We propose and demonstrate a radio-frequency atomic magnetometer with sub-Doppler laser cooled rubidium-87. With a simple and compact design, our system demonstrates a sensitivity of $330~pT/\sqrt{Hz}$ in an unshielded environment, thus…
High-fidelity quantum non-demolition qubit measurement is critical to error correction and rapid qubit feedback in large-scale quantum computing. High-fidelity readout requires passing a short and strong pulse through the qubit's readout…
We demonstrate a high data-rate light-pulse atom interferometer for measuring acceleration. The device is optimized to operate at rates between 50 Hz to 330 Hz with sensitivities of 0.57 {\mu}g/rtHz to 36.7 {\mu}g/rtHz, respectively. Our…
We report the operation of an optical parametric amplifier (OPA) capable of producing gigawatt peak-power laser pulses with tunable wavelength in either the visible or near-infrared spectrum. The OPA has two distinct operation modes (i)…
We report what we believe to be the first radiation-balanced fiber amplifier - a device that provides optical gain while experiencing no temperature rise. The gain medium is a silica fiber with a 21 um-diameter core highly doped with Yb3+…
The many advantages of cryogenically-cooled Single-Flux Quantum (SFQ) circuits imply that the high speed and low voltage output signals must be amplified and interfaced with standard electronics. State-of-the-art low-noise and wide-band…
Optical communication systems, operating in C-band, are reaching their theoretically achievable capacity limits. An attractive and economically viable solution to satisfy the future data rate demands is to employ the transmission across the…