Related papers: Beamforming design for minimizing the signal power…
We consider the design of linear precoders and receivers in a Multiple-Input Single-Output (MISO) Broadcast Channel (BC). We aim at minimizing the transmit power while fullfiling a set of per-user Quality-of-Service (QoS) constraints…
Leveraging the available millimeter wave spectrum will be important for 5G. In this work, we investigate the performance of digital beamforming with low resolution ADCs based on link level simulations including channel estimation, MIMO…
Millimeter-wave communication has the potential to deliver orders of magnitude increases in mobile data rates. A key design challenge is to enable rapid beam alignment with phased arrays. Traditional millimeter-wave systems require a high…
Millimeter wave (mmWave) full-duplex (FD) is a promising technique for improving capacity by maximizing the utilization of both time and the rich mmWave frequency resources. Still, it has restrictions due to FD self-interference (SI) and…
This article describes a probabilistic formulation of a Weighted Power minimization Distortionless response convolutional beamformer (WPD). The WPD unifies a weighted prediction error based dereverberation method (WPE) and a minimum power…
Fully digital massive MIMO systems with large numbers (1000+) of antennas offer dramatically increased capacity gains from spatial multiplexing and beamforming. Designing digital receivers that can scale to these array dimensions presents…
We demonstrate that separating beamforming (i.e., downlink precoding and uplink combining) and channel estimation in multi-user MIMO wireless systems incurs no loss of optimality under general conditions that apply to a wide variety of…
This paper conceives a hybrid beamforming design (HBF) that maximizes the energy efficiency (EE) of an integrated sensing and communication (ISAC)-enabled millimeter wave (mmWave) multiple-input multiple-output (MIMO) system. In the system…
We propose BeamTransformer, an efficient architecture to leverage beamformer's edge in spatial filtering and transformer's capability in context sequence modeling. BeamTransformer seeks to optimize modeling of sequential relationship among…
Given the high degree of computational complexity of the channel estimation technique based on the conventional one-dimensional (1-D) compressive sensing (CS) framework employed in the hybrid beamforming architecture, this study proposes…
Interfering sources, background noise and reverberation degrade speech quality and intelligibility in hearing aid applications. In this paper, we present an adaptive algorithm aiming at dereverberation, noise and interferer reduction and…
We propose blind estimators for the average noise power, receive signal power, signal-to-noise ratio (SNR), and mean-square error (MSE), suitable for multi-antenna millimeter wave (mmWave) wireless systems. The proposed estimators can be…
In this paper we propose minimum mean squared error (MMSE) iterative successive parallel arbitrated decision feedback (DF) receivers for direct sequence code division multiple access (DS-CDMA) systems. We describe the MMSE design criterion…
In this paper, we establish a general framework on the reduced dimensional channel state information (CSI) estimation and pre-beamformer design for frequency-selective massive multiple-input multiple-output MIMO systems employing…
High variations in the OFDM signal envelope cause nonlinear distortion in the power amplifier of the transmitter, which is a major drawback. Peak-to-Average Power Ratio (PAPR) and Cubic Metric (CM) are commonly used for quantifying this…
The high path loss associated with millimeter wave (mmWave) frequency communication can be compensated by large scale antenna arrays such as multiple-input multiple-output (MIMO) systems. The hybrid beamforming architecture which uses fewer…
In this paper, we investigate the design of energy-efficient beamforming for an ISAC system, where the transmitted waveform is optimized for joint multi-user communication and target estimation simultaneously. We aim to maximize the system…
The focus of this paper is on beamforming in a millimeter-wave (mmW) multi-input multi-output (MIMO) setup that has gained increasing traction in meeting the high data-rate requirements of next-generation wireless systems. For a given MIMO…
Hybrid beamforming (HBF) and antenna selection are promising techniques for improving the energy efficiency~(EE) of massive multiple-input multiple-output~(mMIMO) systems. However, the transmitter architecture may contain several parameters…
Recently, dual-function radar communication (DFRC) systems have been proposed to integrate radar and communication into one platform for spectrum sharing. Various signalling strategies have been proposed to embed communication information…