Related papers: Joint Transmit and Receive Beamforming for Tri-dir…
This paper presents an improved technique for solving the inverse problem in magnetic induction tomography (MIT) by considering skin and proximity effects in coils. MIT is a non-contact, noninvasive, and low-cost imaging modality for…
This work studies a low-complexity design for reconfigurable intelligent surface (RIS)-aided multiuser multiple-input multiple-output systems. The base station (BS) applies receive antenna selection to connect a subset of its antennas to…
In this paper, the multiple-input multiple-output (MIMO) transmit beampattern matching problem is considered. The problem is formulated to approximate a desired transmit beampattern (i.e., an energy distribution in space and frequency) and…
Integrated sensing and communication (ISAC) is a promising paradigm for future wireless systems due to spectrum reuse, hardware sharing, and joint waveform design. In dynamic scenes, Doppler shifts degrade both sensing and communication,…
User scheduling and beamforming design are two crucial yet coupled topics for wireless communication systems. They are usually optimized separately with conventional optimization methods. In this paper, a novel cross-layer optimization…
This paper proposes a joint transmitter-receiver design to minimize the weighted sum power under the post-processing signal-to-interference-and-noise ratio (post-SINR) constraints for all subchannels. Simulation results demonstrate that the…
In this paper we explore the use of full-duplex radio to improve the spectrum efficiency in a two-way relay channel where two sources exchange information through an multi-antenna relay, and all nodes work in the full-duplex mode. The…
This letter considers an unmanned aerial vehicle (UAV)-enabled relay communication system for delivering latency-critical messages with ultra-high reliability, where the relay is operating under amplifier-and-forward (AF) mode. We aim to…
We consider a dense small cell (DSC) network where multi-antenna small cell base stations (SBSs) transmit data to single-antenna users over a shared frequency band. To enhance capacity, a state-of-the-art technique known as noncoherent…
To accommodate current machine type communications (MTC), an uplink waveform is proposed where MTC nodes use one carrier to transmit signal, and central nodes demodulate different nodes' signal jointly. Furthermore, the carrier bandwidth is…
In this paper, we consider a prospective receiving hybrid beamforming structure consisting of several radio frequency (RF) chains and abundant antenna elements in multi-input multi-output (MIMO) systems. Due to conventional costly full…
This paper studies a multi-user multiple-input single-output (MISO) downlink system for simultaneous wireless information and power transfer (SWIPT), in which a set of single-antenna mobile stations (MSs) receive information and energy…
In this letter, we consider optimal hybrid beamforming design to minimize the transmission power under individual signal-to-interference-plus-noise ratio (SINR) constraints in a multiuser massive multiple-input-multiple-output (MIMO)…
We consider settings in which T multi-antenna transmitters and K single-antenna receivers concurrently utilize the available communication resources. Each transmitter sends useful information only to its intended receivers and can degrade…
This paper conceives a hybrid beamforming design (HBF) that maximizes the energy efficiency (EE) of an integrated sensing and communication (ISAC)-enabled millimeter wave (mmWave) multiple-input multiple-output (MIMO) system. In the system…
In this paper, we propose a state-of-the-art downlink communication transceiver design for transmissive reconfigurable metasurface (RMS)-enabled simultaneous wireless information and power transfer (SWIPT) networks. Specifically, a feed…
This letter studies joint transmit beamforming and antenna selection at a secondary base station (BS) with multiple primary users (PUs) in an underlay cognitive radio multiple-input single-output broadcast channel. The objective is to…
This paper studies the coordinated beamforming (CoBF) design for the multiple-input single-output interference channel, provided that only channel distribution information is known to the transmitters. The problem under consideration is a…
This paper considers a reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) downlink communication system where hybrid analog-digital beamforming is employed at the base station (BS). We formulate a power minimization…
Controlling the radar beam-pattern by optimizing the transmit covariance matrix is a well-established approach for performance enhancement in multiple-input-multiple-output (MIMO) radars. In this paper, we investigate the joint optimization…