Related papers: Beamforming-Codebook-Aware Channel Knowledge Map C…
The construction of channel gain map (CGM) is essential for realizing environment-aware wireless communications expected in 6G, for which a fundamental problem is how to predict the channel gains at unknown locations effectively by a finite…
Cone-beam computed tomography (CBCT) using only a few X-ray projection views enables faster scans with lower radiation dose, but the resulting severe under-sampling causes strong artifacts and poor spatial coverage. We address these…
Channel knowledge map (CKM) has been recently proposed to enable environment-aware communications by utilizing historical or simulation generated wireless channel data. This paper studies the construction of one particular type of CKM,…
Channel charting builds a map of the radio environment in an unsupervised way. The obtained chart locations can be seen as low-dimensional compressed versions of channel state information that can be used for a wide variety of applications,…
A multi-antenna broadcast channel scenario is considered where a base station delivers contents to cache-enabled user terminals. A joint design of coded caching (CC) and multigroup multicast beamforming is proposed to benefit from spatial…
This paper focuses on advancing outdoor wireless systems to better support ubiquitous extended reality (XR) applications, and close the gap with current indoor wireless transmission capabilities. We propose a hybrid knowledge-data driven…
This paper proposes a deep learning approach to channel sensing and downlink hybrid beamforming for massive multiple-input multiple-output systems operating in the time division duplex mode and employing either single-carrier or…
Beamforming is a key technology in millimeter-wave (mmWave) communications that improves signal transmission by optimizing directionality and intensity. However, conventional channel estimation methods, such as pilot signals or beam…
Future cellular systems based on the use of millimeter waves will heavily rely on the use of antenna arrays both at the transmitter and at the receiver. For complexity reasons and energy consumption issues, fully digital precoding and…
In multi input multi output antenna systems, beamforming is a technique for guarding against the negative effects of fading. However, this technique requires the transmitter to have perfect knowledge of the channel which is often not…
This paper proposes a hybrid beamforming framework for massive multiple-input multiple-output (MIMO) in near-space airship-borne communications. To achieve high energy efficiency (EE) in energy-constraint airships, a dynamic subarray…
Sensor-aided beamforming reduces the overheads associated with beam training in millimeter-wave (mmWave) multi-input-multi-output (MIMO) communication systems. Most prior work, though, neglects the challenges associated with establishing…
Movable antenna (MA) has emerged as a promising technology for future wireless systems. Compared with traditional fixed-position antennas, MA improves system performance by antenna movement to optimize channel conditions. For multiuser…
Existing beamforming-based full-duplex solutions for multi-antenna wireless systems often rely on explicit estimation of the self-interference channel. The pilot overhead of such estimation, however, can be prohibitively high in…
Multiple-input multiple-output (MIMO) systems are well suited for millimeter-wave (mmWave) wireless communications where large antenna arrays can be integrated in small form factors due to tiny wavelengths, thereby providing high array…
The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…
Robust beamforming design under imperfect channel state information (CSI) is a fundamental challenge in multiuser multiple-input multiple-output (MU-MIMO) systems, particularly when the channel estimation error statistics are unknown.…
The semi-airborne transient electromagnetic method (SATEM) is capable of conducting rapid surveys over large-scale and hard-to-reach areas. However, the acquired signals are often contaminated by complex noise, which can compromise the…
Automatic learning algorithms for improving the image quality of diagnostic B-mode ultrasound (US) images have been gaining popularity in the recent past. In this work, a novel convolutional neural network (CNN) is trained using time of…
We propose channel charting (CC), a novel framework in which a multi-antenna network element learns a chart of the radio geometry in its surrounding area. The channel chart captures the local spatial geometry of the area so that points that…