Related papers: Laminar boundary layer separation over a fully por…
The turbulent boundary layer over a Gaussian shaped bump is computed by direct numerical simulation (DNS) of the incompressible Navier-Stokes equations. The two-dimensional bump causes a series of strong pressure gradients alternating in…
The characteristics of pressure-induced laminar separation bubbles (LSBs) over a partially-slip wall, compared with that over a canonical no-slip wall, are studied using direct numerical simulation. Three cases, two utilizing linear…
A pair of Direct Numerical Simulations is used to investigate curvature and pressure effects. One has a Gaussian test bump and a straight opposite wall, while the other has a straight test wall and a blowing/suction distribution on an…
Boundary layer turbulence in coastal regions differs from that in deep ocean because of bottom interactions. In this paper, we focus on the merging of surface and bottom boundary layers in a finite-depth coastal ocean by numerically solving…
Direct numerical simulations are performed to contrast turbulent boundary layers over a concave wall without and with free-stream turbulence. Adverse pressure gradient near the onset of curvature leads to sharp decrease in skin friction and…
Direct numerical simulation (DNS) of a turbulent boundary layer over the Gaussian (Boeing) bump is performed. This boundary layer exhibits a series of adverse and favorable pressure gradients and convex and concave curvature effects before…
A compressible laminar boundary layer developing over an isotropic porous substrate is investigated by asymptotic and numerical methods. The substrate is modeled as an array of cubes. The momentum and enthalpy balance equations are derived…
The characteristics of three-dimensional laminar separation bubbles (LSBs), compared with their quasi-two-dimensional counterparts, are studied using direct numerical simulation. A three-dimensional suction-blowing distribution is applied…
The transitional boundary layer flow over a flat plate is investigated. The boundary layer flow is known to develop unstable Tollmien-Schlichting waves above a critical value of the Reynolds number. However, it is also known that this…
Laminar flow over a bubble mattress is expected to experience a significant reduction in friction since the individual surfaces of the bubbles are shear-free. However, if the bubbles are sufficiently curved, their protrusion into the fluid…
The effect of high-amplitude harmonic surging on airfoil laminar separation bubbles was investigated theoretically, and experimentally in a dedicated surging-flow wind tunnel. A generalized pressure coefficient was developed that accounts…
The spatio-temporal dynamics of separation bubbles induced to form in a fully-developed turbulent boundary layer (with Reynolds number based on momentum thickness of the boundary layer of 490) over a flat plate are studied via direct…
Three different porous substrates (with different pore sizes, s, and permeabilities, K) are used to examine their effect on the structure of boundary layer flow over them. The flow is characterised with single-point hot-wire measurements as…
A phase transition model for porous media in consolidation is studied. The model is able to describe the phenomenon of fluid-segregation during the consolidation process, i.e., the coexistence of two phases differing from fluid content…
A quantitative analysis illustrating salient features of a Laminar Separation Bubble (LSB), its transition forming coherent structures, and associated heat transfer has been performed on a flat plate for varying free stream turbulence (fst)…
The interaction between boundary layer turbulence and a porous layer is the cornerstone to the interface engineering. In this study, the spatial resolved transfer entropy is used to assess the asymmetry of the causal interaction next to a…
The flow properties at the leading edge of a flat plate represent a singularity to the Blasius laminar boundary layer equations; by applying the Lagrangian approach the leading edge velocity profiles of the laminar boundary layer over a…
We develop a model for steady, laminar boundary layers over small-scale textured surfaces. Although the texture is small relative to the boundary-layer thickness, it modifies the flow via a slip length. We use matched asymptotic expansions…
The planar problem of a viscous laminar flow around elliptical cylinders under angle of attack is considered. From the solution of the laminar boundary layer equations using the Loytsyansky local similarity method, the shear stress at the…
We report on a numerical study of the shear flow of a simple two-dimensional model of a granular material under controlled normal stress between two parallel smooth, frictional walls, moving with opposite velocities $\pm$V . Discrete…